gypsum screw

When laying steel wire mesh, according to the laying method from the middle to both sides in turn. Wall plastering engineering use wire mesh material is generally two kinds: one is electroplating, the other is hot dip galvanized. The former has low cost and a wide range of use. The cost of hot-dip galvanized material is slightly higher than that of electroplating, and the cost is high and the life is good to prevent rust. Hot dip galvanizing is in the case of heating plating. After the zinc is melted into liquid form, the base metal is immersed in it so that the zinc interpenetrates with the base metal and binds so tightly that there are no other impurities or defects left in the process.

The formation process of hot dip galvanized layer is the process of forming iron-zinc alloy between the iron matrix and the outside pure zinc layer. The surface of the workpiece forms the iron-zinc alloy layer during the hot dip plating, so that the iron and pure zinc layer is well combined. The process of large roll galvanized wire can be simply described as: when the iron workpiece is immersed in the molten zinc solution, the first zinc and α-iron (body-centered) solid melt is formed on the interface. This is a crystal formed by the matrix metal iron dissolved with zinc atoms in the solid state. The two metal atoms are fused with each other, and the gravitational attraction between the atoms is relatively small.

Common galvanized iron wire equipment is usually used in the barbecue net, barbecue net generally requires to have a long service life, with galvanized iron wire equipment to the wire on a layer of zinc, barbecue net is not easy to be corroded.

At present, some manufacturers also use the process of sandblasting equipment for wire pretreatment, sandblasting process is carried out in the sandblasting room, but in the process of sandblasting, dust will permeate the whole sandblasting room, produce a lot of dust that is not easy to collect, and if the dust will be discharged at will.