fly mesh for cladding

Latest articles

fly mesh for cladding

...

fly mesh for cladding fly mesh for cladding

Read More
  • fly mesh for cladding

    ...

    fly mesh for cladding fly mesh for cladding

    Read More
  • Wire flexibility and elongation is good, can withstand the pressure of mechanical operation, in our country’s industry has played a very important role. There are many kinds of iron wire, the most common is to give black iron wire, galvanized iron wire. The corrosion resistance of the outer coating is effectively improved, but the phenomenon of crevice corrosion will be found after long-term use.

    fly mesh for cladding

    ...

    fly mesh for cladding fly mesh for cladding

    Read More
  • fly mesh for cladding

    ...

    fly mesh for cladding fly mesh for cladding

    Read More
  • The application of electric welding net is more widely, at present it has replaced the use of other parts of the wire mesh, the cost of electric welding net is lower, the production speed is very fast, so it is very popular. Welding net galvanized before the need for processing is recrystallization annealing, because the welding net must maintain a no oxide and no other impurities of pure iron active surface, if you can not keep its surface clean will lead to a bad galvanizing effect, galvanized layer and iron material is not closely combined, so this step is necessary.

    fly mesh for cladding

    ...

    fly mesh for cladding fly mesh for cladding

    Read More
  • fly mesh for cladding

    ...

    fly mesh for cladding fly mesh for cladding

    Read More
  • Moderate rates of foam formation may be harmless. The presence of small, homogeneous particles of large denier in the tank can stabilize the foam layer, but the accumulation of excessive solid particles can cause an explosion.

    fly mesh for cladding

    ...

    fly mesh for cladding fly mesh for cladding

    Read More
  • After a long time of use, it will not rust after the corrosion protection layer on the surface of hot dip galvanized barbed rope, because the material inside the stainless steel barbed rope is the same as the material on the surface.

    fly mesh for cladding

    ...

    fly mesh for cladding fly mesh for cladding

    Read More
  • The different spacing of the thorn rope is mainly in order to save costs to consider, because if they are too close, then obviously a little waste of resources, but the installation is too sparse will not work. Usually the bottom spacing is about 10cm, and the top is up to 20cm, this is because the higher the place is more difficult to climb over, usually more than one meter without the help of tools it is difficult for ordinary people to climb over, and the bottom because of the relatively tight can prevent personnel from drilling in the past.

    fly mesh for cladding

    ...

    fly mesh for cladding fly mesh for cladding

    Read More
  • 

    Popular articles

    Latest articles

    Links