razor wire blade

Packing is also very important. The cut wire should be bundled and tightly packed with plastic film, and then placed in a regular box. The whole box should be filled and sealed. It is better not to have half a box.

The diameter of welded mesh wire for external walls is generally 2.2-ф4.0, and the mesh is generally 25-50.

During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.

1, first of all, the net surface is smooth, mesh are four lines, pitch is the same, whether the weft wire bending (note: the net width is the length of the weft wire), normal weft wire passes through the straight wire of welded wire mesh, with accurate time and the silk repeated welding, make the pitch of welded wire mesh is consistent, with smooth surface, into a square hole, when the net vertical position from the top downwards see, weft wire is straight.