square hole perforated sheet

After the wire mesh appears black spots, you can choose the appearance of treatment to deal with this problem, such as galvanized, paint, dip plastic to deal with, after the appearance of the welding mesh surface smooth and bright, beautiful and generous.

Galvanized wire coating rough, passivation film is not bright, bath temperature is too high. If the cathode current density is too high, zinc content in the bath is too high or sodium hydroxide and DPE content is too low; Electroplating solution with solid particles or excessive foreign metal impurities, will lead to such problems. Solution: If the large roll galvanized wire to the above coating is rough, there may be solid particles in the plating solution. If the roughness of the part is severe, the current density may be too high.

Steel wire mesh is finished by fine welding of active welding equipment. The material can be divided into cold wire drawing, hot dip galvanizing, cold galvanizing, dip plastic, etc. To be used for bridge reinforcement, bridge deck pavement, building reinforcement, etc.

Second: positive and negative twisting rope cost-effective

Once you find that the beginning of it has deformation, rust or broken problems must be timely correction. Generally speaking, the blade barbed rope will not be damaged simply, but it cannot be ensured that it will not happen. Because the local place where the blade barbed rope is required is generally outdoors, the probability of presenting an incident will be greatly increased. For example, in the plantation under the hillside, the blade barbed rope was damaged and deformed by stones rolling down the mountain, which requires manual correction in time, otherwise the deformed blade barbed rope will not only affect the beauty, but also lay hidden dangers for safety.

Additionally, understanding the terminology used to describe welded wire mesh sizes is crucial for interpreting specifications accurately. Terms such as opening size, clear opening, and center-to-center spacing may be used interchangeably to refer to the spacing between wires in the mesh.