1 by 1 wire mesh

Latest articles

1 by 1 wire mesh

...

1 by 1 wire mesh 1 by 1 wire mesh

Read More
  • 1 by 1 wire mesh

    ...

    1 by 1 wire mesh 1 by 1 wire mesh

    Read More
  • 1 by 1 wire mesh

    ...

    1 by 1 wire mesh 1 by 1 wire mesh

    Read More
  • The application of electric welding net is more widely, at present it has replaced the use of other parts of the wire mesh, the cost of electric welding net is lower, the production speed is very fast, so it is very popular. Welding net galvanized before the need for processing is recrystallization annealing, because the welding net must maintain a no oxide and no other impurities of pure iron active surface, if you can not keep its surface clean will lead to a bad galvanizing effect, galvanized layer and iron material is not closely combined, so this step is necessary.

    1 by 1 wire mesh

    ...

    1 by 1 wire mesh 1 by 1 wire mesh

    Read More
  • National standards on the use of wire mesh standards have certain requirements, diameter and mesh size matching use, rather than simply diameter, on the plaster layer to use the mesh should not be greater than 20×20, diameter is not easy to be less than 1mm, just choose diameter is not much meaning, choose 40×40×0.9 and choose 10×10×0.6 wire mesh, Which is better? I’m afraid it’s 10 by 10 by 0.6.

    1 by 1 wire mesh

    ...

    1 by 1 wire mesh 1 by 1 wire mesh

    Read More
  • The purpose of checking on time is to find problems in time. Users should go to the inspection on time if they can not install the blade barbed rope and ignore it. Local rust should be removed in time and local deformation should be corrected in time, and the service life of the blade barbed rope should be extended.

    1 by 1 wire mesh

    ...

    1 by 1 wire mesh 1 by 1 wire mesh

    Read More

  • Post time: 16-11-22

    1 by 1 wire mesh

    ...

    1 by 1 wire mesh 1 by 1 wire mesh

    Read More
  • 1 by 1 wire mesh

    ...

    1 by 1 wire mesh 1 by 1 wire mesh

    Read More
  • (1) The application method of packaging and binding galvanized shaft wire ordering: ① the pulling position on the goods should be reasonably selected. When used to avoid horizontal movement of goods, the pulling position should be as low as possible; When used to avoid overturning the goods, the pulling position can be appropriately high. ② The use of galvanized iron wire [1] pull reinforcement methods mainly include: figure eight, inverted figure eight, cross, zigzag or reverse zigzag and so on. Various pull methods can be used alone, but also two or more than two kinds of use. The pull should be as symmetrical as possible. (3) When pulling reinforcement, the single or double strands of galvanized iron wire will reciprocate around the goods and vehicles between the two tying nodes, and should be pulled tight galvanized iron wire so that the tightness of each strand is as common as possible, and some of the remaining cross around its own rope rod, and the rest of the tail toward the car.

    1 by 1 wire mesh

    ...

    1 by 1 wire mesh 1 by 1 wire mesh

    Read More

  • Post time: 01-08-22

    1 by 1 wire mesh

    ...

    1 by 1 wire mesh 1 by 1 wire mesh

    Read More
  • 

    Popular articles

    Latest articles

    Links