concrete nail price per kilo

Carbon spring steel wire current national and occupational recommendation specifications are divided into two types: one is cold deformation steel wire, also known as cold tension spring steel wire. Cold drawn carbon spring steel wire is first quenched by lead to obtain soxhlet arrangement, and then the surface phosphating, with a large surface reduction rate drawn to the finished scale, the steel wire arrangement is fibrous, has high tensile strength and elastic limit, good winding and change function.

Our country industry chooses the low carbon steel with good quality as raw material, and then produces the quality galvanized iron wire by drawing, galvanizing and other processes. Now the production technology of galvanized iron wire products can be divided into hot plating and electroplating two kinds of methods. No matter which one is chosen, it should be carried out in accordance with the corresponding operating specifications, so as to better ensure the production of good products. For key and important parts with tensile strength greater than 1034mpa before plating, the stress should be released at 200±10℃ for more than 1 hour and 140±10℃ before plating.

Of course, the quality of any kind of product is also affected by the implementation of the specification of the manufacturer, if it is the welding screen manufacturers in the production of their own is not very high implementation of the specification, or in the production line of the procedure specification has declined, or there is no higher requirements on the production link.

1. It is used for enclosure breeding, road isolation, and large-scale breeding enclosure protection. It is recommended that you choose a product with a wire diameter of 3mm.

The advantage of the steel mesh sheet is that the steel mesh sheet ensures the quality of the project and is made by the automatic and intelligent production line under the strict quality control of the factory. The mesh size, steel bar specifications and quality of the steel mesh are strictly controlled. Avoid artificial mesh leakage, bonding is not strong, bonding error and Jerry construction. The mesh steel has large rigidity, outstanding elasticity, uniform, accurate spacing and high welding point strength. Thus greatly improve the quality of the project.

The different spacing of the thorn rope is mainly in order to save costs to consider, because if they are too close, then obviously a little waste of resources, but the installation is too sparse will not work. Usually the bottom spacing is about 10cm, and the top is up to 20cm, this is because the higher the place is more difficult to climb over, usually more than one meter without the help of tools it is difficult for ordinary people to climb over, and the bottom because of the relatively tight can prevent personnel from drilling in the past.