single twist barbed wire

single twist barbed wire

...

single twist barbed wire single twist barbed wire

Read More
  • The service condition and service life of electro galvanized iron wire or component are closely related to the thickness of electroplated coating. The more strict the conditions of use and the longer the service life, the thicker the layer of galvanized iron wire required. Different products, according to the specific environment (temperature, humidity, rainfall, atmospheric composition, etc.) to determine the expected service life of the coating thickness, blind thickening will cause all kinds of waste. But if the thickness is insufficient, it will not reach the expected service life requirements. Different manufacturers, according to their own equipment conditions, in the case of determining the plating, the first preparation of a more complete and reasonable process flow, clear plating parameters, control plating solution concentration, standard operation.

    single twist barbed wire

    ...

    single twist barbed wire single twist barbed wire

    Read More
  • (1) The application method of packaging and binding galvanized shaft wire ordering: ① the pulling position on the goods should be reasonably selected. When used to avoid horizontal movement of goods, the pulling position should be as low as possible; When used to avoid overturning the goods, the pulling position can be appropriately high. ② The use of galvanized iron wire [1] pull reinforcement methods mainly include: figure eight, inverted figure eight, cross, zigzag or reverse zigzag and so on. Various pull methods can be used alone, but also two or more than two kinds of use. The pull should be as symmetrical as possible. (3) When pulling reinforcement, the single or double strands of galvanized iron wire will reciprocate around the goods and vehicles between the two tying nodes, and should be pulled tight galvanized iron wire so that the tightness of each strand is as common as possible, and some of the remaining cross around its own rope rod, and the rest of the tail toward the car.

    single twist barbed wire

    ...

    single twist barbed wire single twist barbed wire

    Read More

  • Post time: 12-01-23

    single twist barbed wire

    ...

    single twist barbed wire single twist barbed wire

    Read More
  • black

    single twist barbed wire

    ...

    single twist barbed wire single twist barbed wire

    Read More
  • galvanized

    single twist barbed wire

    ...

    single twist barbed wire single twist barbed wire

    Read More

  • Post time: 03-04-23

    single twist barbed wire

    ...

    single twist barbed wire single twist barbed wire

    Read More
  • No less than 5 disks should be extracted from each inspection lot for diameter error inspection. 1 point of steel wire should be extracted from each disk to measure steel wire diameter, and the actual diameter of steel wire at this point should be taken as the average value of the two vertical directions. The diameter error of cold-drawn low carbon steel wire should conform to the rules in the table below. The unqualified inspection batches shall be checked one by one, and the qualified batches can be used for engineering.

    single twist barbed wire

    ...

    single twist barbed wire single twist barbed wire

    Read More
  • galvanized

    single twist barbed wire

    ...

    single twist barbed wire single twist barbed wire

    Read More
  • 

    Popular articles

    Latest articles

    Links