galvanized wire price

1, barbed rope protection net center line along the road within the land boundary 20 to 50 cm set.

There is a good toughness and elasticity, in short, it can be easily made into a variety of shapes, and zinc as a coating is silver, very beautiful. This feature makes hot-dip galvanized wire handicrafts, wire mesh and other aspects are also used. Hot plating wire selection of high quality low carbon steel wire rod processing, is the selection of high quality low carbon steel, after drawing forming, pickling rust removal, high temperature annealing, cooling and other processes.

In order to pack and bundle galvanized wire on the surface of the deposit layer to remove the surface film, surface inclusion and other defects can be found and treated by conventional technology; Excess foam is caused by soaps and saponable fatty surfactants being brought into the tank. Moderate foam formation rates may be harmless. Small homogeneous particles of large denier present in the tank can stabilize the foam layer. To remove surface active substances by matting with activated carbon. Or filtration to make the foam less stable, which are effective measures; Other measures should also be taken to reduce the intake of surfactant. The electroplating speed can be significantly reduced by the introduction of organic matter. Although the chemical formula is conducive to a high deposition rate, the coating thickness cannot meet the requirements after the organic matter is loaded, so activated carbon can be used to treat the tank.

Slowly through the axial flow fan or exhaust hole directly discharged to the sand blasting room, so that the power of dust discharge is low. And in the discharge of dust because there is no further treatment, so the discharge of dust will seriously pollute the sandblasting room and the surrounding environment, the health of the site staff will also harm.

And the role of wire mesh in the exterior wall plastering if from an Angle to sail a method of anti-falling, the role of anti-cracking is relatively small, because of the problem of orientation; And about the external insulation system is used in the tile veneer, as for the role should also be anti falling followed by anti-cracking, so the grid should be selected 10×10×0.6, these are some experience selection, grid conversion from the national provisions of the wire mesh standard, choose the level of steel content conversion.