8 mesh screen

Great attention should be paid to pickling of large rolls of galvanized wire. Acid is highly corrosive. Therefore, when adding acid, the acid must be poured into the water, and it is along the wall of the cylinder, and not thrown down at once, so as not to cause splashing. Remember the order of acid pouring, acid into water rather than water into acid, water into acid will cause splashing and boiling, when pouring acid must wear protective glasses, beside must ensure that there are no non-professional people watching, so as not to cause some acid splashing danger.

Although galvanized hook mesh is outstanding because of its surface, this does not mean that this hook mesh product is not useful. From the point of view of people’s use of it, this hook mesh products through a surface of galvanized treatment, whether it is wind and sun, or man-made inadvertent damage, will not bring a little harm to it, so the more comprehensive use of galvanized hook mesh products will then be widely used in several fields.

The management system of the rinsing water after wire pickling should be discharged regularly and regularly, and the rinsing water should be kept clean and low acid value as far as possible. It is more appropriate to control the pH value of 3. The concentration of plating aid should not be too high. The hot plating wire must be added with ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution is controlled within the range of 50~80g/L. If ammonium chloride or zinc chloride is added without reference to the results of laboratory analysis, it should be criticized and educated, and economic treatment should be given if necessary.