358 welded mesh

Latest articles

358 welded mesh

...

358 welded mesh 358 welded mesh

Read More
  • The key and important parts with tensile strength greater than 1034Mpa should be relieved of stress at 200±10℃ for more than 1 hour before plating, and the carburized or surface hardened parts should be relieved of stress at 140±10℃ for more than 5 hours. The cleaning agent used for cleaning shall have no effect on the binding force of the coating and no corrosion on the substrate. Acid activation Acid activation solution should be able to remove corrosion products and oxide film (skin) on the surface of parts without excessive corrosion on the matrix.

    358 welded mesh

    ...

    358 welded mesh 358 welded mesh

    Read More
  • 358 welded mesh

    ...

    358 welded mesh 358 welded mesh

    Read More
  • 358 welded mesh

    ...

    358 welded mesh 358 welded mesh

    Read More

  • Post time: 24-04-22

    358 welded mesh

    ...

    358 welded mesh 358 welded mesh

    Read More
  • Using activated carbon mat to remove surface active substances, or through filtration to make the foam is not too stable, this is an effective measure; Other measures should also be taken to reduce the amount of surfactant introduced to Z.

    358 welded mesh

    ...

    358 welded mesh 358 welded mesh

    Read More
  • 358 welded mesh

    ...

    358 welded mesh 358 welded mesh

    Read More
  • The form of installation: in the top with the various cage tied together at least as wrapped stone cage net that combination closely not easy to use bad. If the local bandaging is appropriate, it can increase the stability of the structure. There are a lot of grid edge, if the stone cage net only hook in the cage edge and not prepared in the cage edge, even in loose.

    358 welded mesh

    ...

    358 welded mesh 358 welded mesh

    Read More
  • 

    Popular articles

    Latest articles

    Links