locker expanded mesh

locker expanded mesh

...

locker expanded mesh locker expanded mesh

Read More
  • Compared with galvanizing, hot-dip galvanizing has lower production cost and less environmental impact than galvanizing. Because the coating obtained is thicker, hot-dip galvanizing has better protective performance than electric galvanizing, so it is an important protective coating for steel parts used in harsh working environment. Hot-dip galvanized products are widely used in chemical equipment, petroleum processing, ocean exploration, metal structure, electric power transmission, shipbuilding and other industries.

    locker expanded mesh

    ...

    locker expanded mesh locker expanded mesh

    Read More
  • Zinc coating on steel and ferrous metal plays an anodic role, it is commonly used for those parts subjected to atmospheric or water action, but zinc coating only when the water temperature below 60℃, the anode properties. When the temperature is higher, the potential changes and the zinc to iron becomes the cathode. Therefore, for parts subjected to hot water (such as steam boilers), the zinc skeleton must be approximately 70 microns thick and void free. For parts subjected to low or normal temperature or atmospheric action, zinc coating without pinholes is not necessary.

    locker expanded mesh

    ...

    locker expanded mesh locker expanded mesh

    Read More
  • locker expanded mesh

    ...

    locker expanded mesh locker expanded mesh

    Read More
  • Heavy duty hexagonal mesh made of steel wire by special machinery woven into a hexagonal mesh net. This kind of mesh can be cut and assembled into fence mesh, mountain hanging mesh, vegetation three-dimensional mesh, composite, etc.

    locker expanded mesh

    ...

    locker expanded mesh locker expanded mesh

    Read More

  • Post time: 18-11-22

    locker expanded mesh

    ...

    locker expanded mesh locker expanded mesh

    Read More
  • Hot dip galvanizing has been used for more than 150 years, and its principle has not changed so far. The steel structure should be fully immersed in zinc at one time to achieve uniform galvanized film structure. If it is too long or too wide to be dipped twice, the zinc layer at the joint will appear rough, too thick and so on. In addition, if the single weight of steel structure is too heavy, it will make its operation difficult if it exceeds the load of galvanizing equipment. Therefore, the communication with the hot dip galvanizing factory in advance.

    locker expanded mesh

    ...

    locker expanded mesh locker expanded mesh

    Read More
  • 

    Popular articles

    Latest articles

    Links