custom perforated aluminum sheet

Strength of galvanized wire: tensile strength is the great tensile stress that the material can withstand before tensile fracture; Yield strength has two indexes: upper yield and lower yield. It is a process in which the stress does not increase but the deformation continues to occur during the tensile process. When the force value drops for the first time, the major stress is the yield strength, and the yield strength must be less than the tensile strength.

Slowly through the axial flow fan or exhaust hole directly discharged to the sand blasting room, so that the power of dust discharge is low. And in the discharge of dust because there is no further treatment, so the discharge of dust will seriously pollute the sandblasting room and the surrounding environment, the health of the site staff will also harm.

The production process of large rolls of galvanized wire is a level of drawing, through the mold into a slightly smaller diameter than the original. And so on down to the desired length. One pull is not desirable, must be numbered, from coarse to fine is dependent on metal ductility. If it changes too much it just breaks. After drawing to a certain diameter, galvanized, so that the finished product.

Galvanized iron wire is divided into hot-dip galvanized wire and cold galvanized wire, using low carbon steel wire processing, after drawing forming, pickling rust removal, high temperature annealing, hot-dip galvanized, cooling and other processes. With good toughness and elasticity, the amount of zinc can reach 300 grams/square meter. It has the characteristics of thick galvanized layer and strong corrosion resistance. Galvanized iron wire can cut off the tie wire used in the building, the length is 20cm 30cm 40cm, can be cut off according to the requirements.

What is Heat Tape?

Where Can You Use Polyethylene Tape?

Residential control boxes are relatively small regulators deployed in homes and residential complexes to manage domestic electrical systems. The fuse boxes or breaker panels you have come across in your apartment are most likely residential control boxes.

Elongation: 685%