2x2 aluminum screen framing

A remarkable characteristic of stainless steel wire rope is its inherent corrosion resistance to concentrated nitric acid and dilute nitric acid, which makes it easy to be distinguished from most other metals or alloys. But high carbon 420 and 440 steel in the nitric acid point test is slightly corroded, non-ferrous metal encountered concentrated nitric acid is immediately corroded, and dilute nitric acid has strong corrosion on carbon steel.

The life of the “wire”, is actually “low carbon steel wire”, carbon content in less than 0.2%. The surface is usually coated with zinc plating because it is easy to rust. Under atmospheric conditions, the galvanized layer will not rust before most of the fall off, relatively soft. The life of the “steel wire”, is carbon content in about 0.6% of the “carbon steel wire”, or carbon content in about 0.8% of the “high carbon steel wire”, they have enough hardness and elasticity after appropriate heat treatment, high strength. Uses such as winding ordinary spring and so on.

Aquaculture galvanized welding mesh is still in construction projects and has been well used. It is because of such a net that it can now save time and effort in construction projects. Not only in this industry, such as breeding and breeding in nursery stock and supermarket shelves, have begun to use such nets, to meet the needs of the industry, but also can well help people in their work.

If the coating roughness is not caused by the above reasons, it may be caused by impurities in the plating solution. Can take a small amount of electroplating solution, filtration test, and then take a small amount of electroplating solution, with zinc powder treatment after the test, check the problem is solid particles or copper, lead and other foreign metal impurities caused by. One by one, it’s not hard to find the cause of the problem. Galvanized iron wire coating blister, poor adhesion.

Zinc pot workers should be determined to do duty and responsibility. Do not leave the post without leave, always observe the change of hot plating wire galvanized layer, and according to the analysis results, master the asbestos block gap friction, how long it takes to press, replace the pressing face; Adjust the working face; Until all four faces of the asbestos block are used up, maintenance workers can continue to use the asbestos block after repair when necessary to reduce the consumption of asbestos block.