6 gauge welded wire fence

The entire steel surface is protected, and the melted zinc is easily coated evenly, whether in the interior of the pipe fitting in a depression, or in any other corner where the coating is difficult to access. The hardness of galvanized coating is greater than that of steel. The Eta layer of the upper layer of Z is only 70 DPN hardness, so it is easy to be dented by collisions. However, the hardness values of the lower layer of Zeta layer and delta layer are 179 and 211 DPN respectively, which are higher than that of the iron material of 159 DPN. Therefore, its impact resistance and wear resistance are quite good.

The cleaning agent used for cleaning has no effect on the adhesion of the coating and no corrosion on the base material. Acid activation Acid activation solution should be able to remove corrosion products and oxide film from the surface of parts without excessive corrosion of the matrix. Zinc plating may be zinc plated with zincate or chloride and appropriate additives shall be used to obtain a coating that meets the requirements of this standard. After light plating, light treatment is carried out. Passivated parts requiring hydrogen removal shall be passivated after hydrogen removal. Activation with 1% H2SO4 or 1% hydrochloric acid for 5 ~ 15s prior to passivation.

5, the concentration of plating aid can not be too high, which is a factor that can not be ignored to reduce zinc consumption. The concentration of plating aid should not be too high. The galvanized line must be added with ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution should be controlled within the range of 50~80g/L. If ammonium chloride or zinc chloride is arbitrarily added without the results of laboratory analysis, it should be criticized and educated, and economic treatment should be given if necessary.