small hole mesh sheet

small hole mesh sheet

...

small hole mesh sheet small hole mesh sheet

Read More
  • 3, reduce the bivalent iron ion in the plating aid used for hot plating wire, reduce the formation of zinc slag

    small hole mesh sheet

    ...

    small hole mesh sheet small hole mesh sheet

    Read More
  • The most obvious difference in a short time is the cross section of this piece, hot dip galvanized barbed wire because of surface anticorrosion treatment, so there will be rust in the cross section of this piece, and stainless steel barbed wire because the internal raw materials and surface raw materials are consistent, so there is no such situation.

    small hole mesh sheet

    ...

    small hole mesh sheet small hole mesh sheet

    Read More
  • small hole mesh sheet

    ...

    small hole mesh sheet small hole mesh sheet

    Read More
  • small hole mesh sheet

    ...

    small hole mesh sheet small hole mesh sheet

    Read More
  • Black iron wire application in the process, the main is through the hot metal billet rolling into six point five mm wire rod, and then put it in the drawing into a line of different diameter, the plant and then gradually narrow drawing plate aperture, cooling and annealing, plating process, such as making a variety of different specifications of the wire, the wire compared with ordinary black iron wire, will be more softer, The softness is also very uniform, the color is consistent, widely used in the construction industry, mining, chemical industry, welding mesh, welding hanger, reprocessing industry, etc.

    small hole mesh sheet

    ...

    small hole mesh sheet small hole mesh sheet

    Read More
  • Raw material of wire mesh sheet cold drawn low carbon steel wire base material can choose low carbon steel hot rolled disk bar or hot rolled smooth steel bar. The base material number and diameter of cold-drawn low carbon steel wire can be confirmed according to the rules in the table below. During the cold drawing process, the surface shrinkage rate of each drawing should not be greater than the wire mesh before cold drawing. Annealing shall not be carried out during wire drawing. If butt welding is required, the same production unit and base material of the same number should be selected. The appearance quality of wire mesh should not affect wire drawing. When the welding function is poor or brittle fracture occurs, special inspection should be carried out according to relevant standards.

    small hole mesh sheet

    ...

    small hole mesh sheet small hole mesh sheet

    Read More

  • Post time: 20-12-22

    small hole mesh sheet

    ...

    small hole mesh sheet small hole mesh sheet

    Read More
  • 

    Popular articles

    Latest articles

    Links