concrete pin nails

Galvanized wire coating rough, passivation film is not bright, bath temperature is too high. If the cathode current density is too high, zinc content in the bath is too high or sodium hydroxide and DPE content is too low; Solid particles or excessive foreign metal impurities in the electroplating solution can cause such problems. Solution: If the coating of large galvanized wire is rough, there may be solid particles in the plating solution. If the roughness of the part is severe, the current density may be too high.

The tensile strength of steel wire is high and the hardness is high. In the flattening process, the longitudinal movement resistance of steel wire per unit volume increases and the elongation decreases. The steel wire unit volume will move to the lateral resistance smaller, the width of the increase. On the contrary, the wire is easy to extend lengthwise, and its width decreases. This is the production of high steel wire hardness is easy to wide, small hardness, easy to stretch out of wide reasons. If the tensile strength deviation of steel wire is large, the hardness uniformity of steel wire strip is poor, the width difference of the billet rolled into large, will seriously affect the quality of the billet.

Different hot dip galvanizing process is divided into two categories of annealing outside the line and annealing in the line, hot dip galvanizing is in the hot melt zinc liquid immersion plating, production speed, thick but uneven coating, the market allows Z low thickness of 45 microns, Z high can reach more than 300 microns. It is dark in color, consumes more zinc metal, forms infiltration layer with base metal, and has good corrosion resistance. Hot dip galvanizing can be maintained for decades in outdoor environment.

Correction is the hot galvanized wire or cold galvanized wire secondary treatment, the surface after correction is smooth and shiny, and the tensile strength is stronger, so that it is not easy to break. Now it is usually used for screen industry will be changed, which can improve the quality. In addition, clothes rack, communication, high voltage line will be changed to prevent breakage.

Hook mesh from the point of view of weaving quality inspection requirements, hook mesh wire and silk staggered can not loose, the whole piece of hook mesh can not loose deformation. Of course, if the customer special requirements out of the net, showing loose phenomenon can not blame the production side. Whether the mesh meets the specification requirements and the wire diameter meets the wire diameter.

Fluorosilicone