4x8 perforated metal sheet

For single-layer wound non-rotating wire rope, it is necessary to strictly abide by the above principles, otherwise it is easy to cause permanent deformation of wire rope structure; In the case of multilayer winding, the rotation of the rope is determined by the orientation of the reel’s rope groove to lay the foundation for the next layer. The friction between the wire rope and the extrusion pressure of the multi-layer winding drum are large, and the disorderly rope phenomenon is easy to occur. Therefore, the wire rope with a diameter slightly smaller than the pitch of the rope groove and the diameter of the rope groove should be selected to add the touch area between the wire rope and the drum.

In the electroplating tank through the current unidirectional make zinc plating on the metal surface gradually, the production speed is slow, the coating is uniform, the thickness is thin, usually only 3-15 micron, the appearance is bright, smooth, beautiful, poor corrosion resistance, generally will rust in a few months. The production process of hot wire plating mainly includes: preparation of the original plate → pre-plating treatment → hot dip plating → post-plating treatment → finished product inspection, etc. According to custom often according to plating pretreatment method.

Regular maintenance and maintenance, save a lot of time, but also save the cost of maintenance and maintenance. With good stability, good corrosion resistance, greatly prolong the service life. More kinds, can be selected according to different uses, making annealing wire device is simple, improve the utilization rate of the device.