16d galvanized common nails

The formation process of hot dip galvanized layer is the process of forming iron-zinc alloy between the iron matrix and the outside pure zinc layer. The surface of the workpiece forms the iron-zinc alloy layer during the hot dip plating, so that the iron and pure zinc layer is well combined. The process of large roll galvanized wire can be simply described as: when the iron workpiece is immersed in the molten zinc solution, the first zinc and α-iron (body-centered) solid melt is formed on the interface. This is a crystal formed by the matrix metal iron dissolved with zinc atoms in the solid state. The two metal atoms are fused with each other, and the gravitational attraction between the atoms is relatively small.

In the rolling process, if the surface of the steel wire is rough, the relative friction coefficient of the steel wire and roll increases, the friction resistance increases, the steel wire elongation decreases, the width increases. In the production of weighted leather material is easy to wide, is because of its rough surface. On the contrary, the surface of the steel wire is smooth, because the friction resistance between the steel wire and the roll is small, it is easy to extend, and the width is small. Domestic steel wire in order to prevent rust, the surface coated with butter, such as butter removal is not clean, easy to slip when rolled flat, also affect its width.

Ring corn with: used as a ring corn net, generally use mesh 5cm*7cm or 5cm*5cm of the original galvanized welding net, wire diameter from 1.8mm-2.3mm, height of 1.2m – 1.8m.

2.0*2.0mm 12 meters per kilogram

The four basic parts of a tapered roller bearing are:

In summary, the purpose of the deep groove type of ball races in a ball bearing is to enable the bearing to support radial and axial loads, reduce friction, facilitate smooth rotation, distribute loads evenly, and contribute to the overall efficiency and reliability of the bearing in various mechanical applications.