wire mesh for fire pit

wire mesh for fire pit

...

wire mesh for fire pit wire mesh for fire pit

Read More
  • 3. Temporary protection, breeding chickens and ducks, etc., it is recommended that you choose 2mm wire diameter products.

    wire mesh for fire pit

    ...

    wire mesh for fire pit wire mesh for fire pit

    Read More
  • The life of the “wire”, is actually “low carbon steel wire”, carbon content in less than 0.2%. The surface is usually coated with zinc plating because it is easy to rust. Under atmospheric conditions, the galvanized layer will not rust before most of the fall off, relatively soft. The life of the “steel wire”, is carbon content in about 0.6% of the “carbon steel wire”, or carbon content in about 0.8% of the “high carbon steel wire”, they have enough hardness and elasticity after appropriate heat treatment, high strength. Uses such as winding ordinary spring and so on.

    wire mesh for fire pit

    ...

    wire mesh for fire pit wire mesh for fire pit

    Read More
  • Hot dip galvanizing is to make the molten metal react with the iron matrix to produce an alloy layer, so that the matrix and the coating are combined. Hot dip galvanizing is to first pickling the iron and steel parts. In order to remove the iron oxide on the surface of the iron and steel parts, after pickling, it is cleaned in the tank of ammonium chloride or zinc chloride aqueous solution or mixed aqueous solution of ammonium chloride and zinc chloride, and then sent into the hot dip plating tank. Hot dip galvanizing has the advantages of uniform coating, strong adhesion and long service life.

    wire mesh for fire pit

    ...

    wire mesh for fire pit wire mesh for fire pit

    Read More
  • Zinc pot workers should be determined to do duty and responsibility. Do not leave the post without leave, always observe the change of hot plating wire galvanized layer, and according to the analysis results, master the asbestos block gap friction, how long it takes to press, replace the pressing face; Adjust the working face; Until all four faces of the asbestos block are used up, maintenance workers can continue to use the asbestos block after repair when necessary to reduce the consumption of asbestos block.

    wire mesh for fire pit

    ...

    wire mesh for fire pit wire mesh for fire pit

    Read More
  • Zinc coating on steel and ferrous metal plays an anodic role, it is commonly used for those parts subjected to atmospheric or water action, but zinc coating only when the water temperature below 60℃, the anode properties. When the temperature is higher, the potential changes and the zinc to iron becomes the cathode. Therefore, for parts subjected to hot water (such as steam boilers), the zinc skeleton must be approximately 70 microns thick and void free. For parts subjected to low or normal temperature or atmospheric action, zinc coating without pinholes is not necessary.

    wire mesh for fire pit

    ...

    wire mesh for fire pit wire mesh for fire pit

    Read More
  • 

    Popular articles

    Latest articles

    Links