perforated stainless steel mesh

The smaller the mesh of decorative hook mesh, the finer the demand wire, the larger the mesh, the thicker the demand wire. For example, 6.5cm mesh aperture, the required iron diameter is 3.5mm-4mm. Then a fine welding will be broken, and then thick and heavy, workers can not bear.

In addition, before the steel wire enters the zinc liquid, covered with a layer of insulation material containing zinc oxide reducing agent, can reduce the heat loss and zinc ash floating. In addition, adding zinc-5% aluminum-mixed rare earth alloy to the zinc solution, when the zinc solution contains 0.002%-0.005% aluminum mass fraction, can obviously increase the brightness of the zinc layer, and prevent the zinc solution surface oxidation caused by excessive zinc ash.

Many people do not know how to choose high quality cut wire, I will give you a detailed introduction. The raw material of cutting wire is divided into: stainless steel cutting wire, copper cutting wire, steel wire cutting wire, copper plated steel wire cutting wire, galvanized steel wire cutting wire, iron wire cutting wire, aluminum wire cutting wire and so on.

Thus, when zinc is sufficient in a solid melt, the two atoms of zinc and iron disperse with each other. The zinc atoms in the iron matrix are moved into the lattice of the matrix, and the iron elements are gradually formed into alloys. The zinc composition of iron and intermetallic compound FeZn13 in molten zinc solution and the bottom of hot galvanized sheet can be used as zinc slag. The pure zinc layer composed of zinc leaching solution is hexagonal crystal.