72 in x 50 ft chicken wire

B. When the thickness of the plating is greater than 4 mm, the zinc adhesion should not be less than 610g/m, that is, the average thickness of the zinc layer should not be less than 86 microns.

In order to remove defects such as surface film layer and surface inclusion of large roll galvanized wire, it can be treated by conventional technology. The presence of small homogeneous particles of large denier in the tank can stabilize the foam layer, but the accumulation of too many solid particles can cause explosion. Activated carbon mat to remove surface active substances, or through filtration to make the foam less stable, these are effective measures; Other measures should also be taken to minimize the intake of surface active substances. The electroplating speed can be significantly reduced by the introduction of organic matter.

One is to do a good job of galvanized wire packaging, avoid bump, to ensure the integrity of the zinc layer;

The characteristics of hexagonal wire mesh: strong structure, flat surface, with good corrosion resistance, oxidation resistance and so on.

The quantity should be the same as the contract, cold drawing, carefully record the quantity of each specification and packing method. If there is a label, check whether the label is correct and take a photo to confirm. Each roll of iron wire is fastened with galvanized packing tape, and then tightly bound with a very strong transparent plastic bag. The outer layer of coated iron wire is wrapped with white braided cloth, and the outer layer of galvanized iron wire is wrapped with green braided cloth, so as to ensure that the packaging will not be lax in the transportation process. One end of the wire must be clearly marked and the other end left on the outer layer for easy connection by other wires.