flywire mesh

4. Substrate material: The substrate material of electrogalvanized wire also has a certain impact on its corrosion resistance. The substrate of different materials has different chemical properties and electrochemical activities, and the corrosion performance is different under different environmental conditions, and the compatibility with zinc layer will also have a certain impact on the corrosion performance.

Electric welding mesh can be made into the form of mesh, mesh surface can be used to dip plastic or spray plastic process, forming a layer of protective film on the surface of electric welding mesh, can effectively make the wire and the outside of the water or with corrosive substances isolation, can achieve the effect of increasing the use of time, can also make the mesh surface show different colors, so that the mesh to achieve beautiful effect. Impregnated mesh is usually used for outdoor, and column link, can play a protective anti-theft effect.

Raw material of wire mesh sheet cold drawn low carbon steel wire base material can choose low carbon steel hot rolled disk bar or hot rolled smooth steel bar. The base material number and diameter of cold-drawn low carbon steel wire can be confirmed according to the rules in the table below. During the cold drawing process, the surface shrinkage rate of each drawing should not be greater than the wire mesh before cold drawing. Annealing shall not be carried out during wire drawing. If butt welding is required, the same production unit and base material of the same number should be selected. The appearance quality of wire mesh should not affect wire drawing. When the welding function is poor or brittle fracture occurs, special inspection should be carried out according to relevant standards.