loop tie wire

Latest articles

(1) The application method of packaging and binding galvanized shaft wire ordering: ① the pulling position on the goods should be reasonably selected. When used to avoid horizontal movement of goods, the pulling position should be as low as possible; When used to avoid overturning the goods, the pulling position can be appropriately high. ② The use of galvanized iron wire [1] pull reinforcement methods mainly include: figure eight, inverted figure eight, cross, zigzag or reverse zigzag and so on. Various pull methods can be used alone, but also two or more than two kinds of use. The pull should be as symmetrical as possible. (3) When pulling reinforcement, the single or double strands of galvanized iron wire will reciprocate around the goods and vehicles between the two tying nodes, and should be pulled tight galvanized iron wire so that the tightness of each strand is as common as possible, and some of the remaining cross around its own rope rod, and the rest of the tail toward the car.
loop tie wire
...

loop tie wire2025-08-16 15:58 【loop tie wire】
Read More
Powder coating color is divided into: blade thorn rope blue, grass green, dark green, yellow. Spray blade gill net is made of hot-dip galvanized steel plate or stainless steel sheet stamped out of sharp knife sheet, high tension galvanized steel wire or stainless steel wire as core wire combination of blocking devices. Because the shape of the thorn rope is not easy to contact, so it can reach excellent protective barrier effect. The primary raw materials of products are galvanized sheet, stainless steel plate, high quality low carbon steel wire (electric galvanized, hot galvanized, coated plastic, plastic spray) wire, blue, green, yellow and other colors.
loop tie wire
...

loop tie wire2025-08-16 15:22 【loop tie wire】
Read More
Post time: 10-05-23
loop tie wire
...

loop tie wire2025-08-16 15:18 【loop tie wire】
Read More
In order to pack and bundle galvanized wire on the surface of the deposit layer to remove the surface film, surface inclusion and other defects can be found and treated by conventional technology; Excess foam is caused by soaps and saponable fatty surfactants being brought into the tank. Moderate foam formation rates may be harmless. Small homogeneous particles of large denier present in the tank can stabilize the foam layer. To remove surface active substances by matting with activated carbon. Or filtration to make the foam less stable, which are effective measures; Other measures should also be taken to reduce the intake of surfactant. The electroplating speed can be significantly reduced by the introduction of organic matter. Although the chemical formula is conducive to a high deposition rate, the coating thickness cannot meet the requirements after the organic matter is loaded, so activated carbon can be used to treat the tank.
loop tie wire
...

loop tie wire2025-08-16 14:55 【loop tie wire】
Read More
1, barbed rope protection net center line along the road within the land boundary 20 to 50 cm set.
loop tie wire
...

loop tie wire2025-08-16 14:44 【loop tie wire】
Read More
loop tie wire
...

loop tie wire2025-08-16 14:35 【loop tie wire】
Read More
Post time: 05-05-22
loop tie wire
...

loop tie wire2025-08-16 14:34 【loop tie wire】
Read More
The size of the dog cage is generally relatively small, suitable for indoor small dogs, dog cage is easy to carry, go out to compare the use, folding dog cage high strength steel wire and steel pipe material, the outer layer spray treatment. Strong texture, excellent rust resistance, the dog cage inside the tray, can be pulled out, convenient to clean the dog’s urine and feces, folding, dog cage is suitable for families and pet stores to raise more pet dogs.
loop tie wire
...

loop tie wire2025-08-16 13:59 【loop tie wire】
Read More
loop tie wire
...

loop tie wire2025-08-16 13:42 【loop tie wire】
Read More
loop tie wire
...

loop tie wire2025-08-16 13:17 【loop tie wire】
Read More

1
2
3
4
5
6
7
8
9
10

Popular articles

Latest articles

But there are some necessary precautions in the production of galvanized wire. Remove all tools and piles on the work site and equipment that hinder activities, and slowly put the wire into the cylinder during pickling to prevent acid splashing on the body. When adding acid, the acid must be slowly poured into the water. Do not pour water into the acid to prevent acid spillage and injury. Workers should wear protective glasses when working. Then in the handling of wire and other items, it is strictly prohibited to push hard.

Links