electro galvanized wire

The acceptance of cold-drawn low carbon steel wire shall be conducted according to the same production unit, the same raw material, the same diameter, and shall not exceed 30T for an inspection lot, and check the base material into the factory or out of the inspection statement. The inspection items for each inspection lot are appearance quality, diameter error, tensile test (including tensile strength and elongation) and repeated bending test.

And high quality data is constrained by production cost and production conditions, so some welding mesh manufacturers do not meet this requirement, natural in this case, there is no way to improve the strength of the product. In addition to the data, there is the production process, even if it is the best data, but the manufacturer does not meet the production process requirements in the welding, it will also form the product under high pressure welding, so this is also a decline in strength, the process conditions of different manufacturers are also very different, so it forms the market above the product has a difference in strength.

Paint on the galvanized layer, the binding force between each other and the baking temperature of the paint has a great relationship, after galvanized coating alkyd paint, adhesion is no problem. Galvanized amino paint, paint adhesion is not good. Do two bottom two surface, adhesion is ok, if the two bottom two surface to two bottom three surface, that is, more paint, more baking once, again test adhesion is very poor, poor to the paint from the galvanized layer of pieces torn off.