wire filter screen

Smelting technology is good, advanced equipment, advanced process of large stainless steel plant whether in the control of alloy elements, impurities removal, billet cooling temperature control can be guaranteed, so the product quality is stable and reliable, good internal quality, not easy to rust. On the contrary, some small steel equipment is backward, backward process, smelting process, impurities can not be removed, the production of products will inevitably rust.

Customers in the order of wire mesh will often shop around, most customers are in comparison with manufacturers to give the product price, the company tells you, do not blindly compare the price. To standards, production technology, manufacturers and other factors lead to different prices.

The formation process of hot dip galvanized layer is the process of forming iron-zinc alloy between the iron matrix and the outside pure zinc layer. The surface of the workpiece forms the iron-zinc alloy layer during the hot dip plating, so that the iron and pure zinc layer is well combined. The process of large roll galvanized wire can be simply described as: when the iron workpiece is immersed in the molten zinc solution, the first zinc and α-iron (body-centered) solid melt is formed on the interface. This is a crystal formed by the matrix metal iron dissolved with zinc atoms in the solid state. The two metal atoms are fused with each other, and the gravitational attraction between the atoms is relatively small.

Power plant insulation pipe insulation layer to be wrapped with metal mesh, commonly used is galvanized hexagonal mesh, the general specification of aperture 1.5-2.5cm, wire diameter: 0.5-1.0mm.

2.0*2.0mm indicates that the two strands are 2.0mm silk, and the barbed wire wrapped around the strands is also 2.0mm silk.

Metal-cased oil seals are usually installed in a housing bore made of the same material. This allows for equal expansion and contraction of the materials during operation, preventing leakage. This type performs best when used in a steel housing.

If you are installing an o-ring to serve as a backup, make sure you put it on the low-pressure side of the system. This will make the high-pressure side push the o-ring against the backup.

FKM or FPM, which is in well-known brand Viton™, can withstand higher liquid temperatures of up to 180 ˚C. FKM is highly resistant to strong acids and bases, as well as to synthetic oils and greases. Glycol-based oil and grease, however, can also damage FKM.

The temperature range of the mechanism in which the seal is installed must not exceed the temperature range of the seal elastomer.