expanded metal mesh builders warehouse

Raw material of wire mesh sheet cold drawn low carbon steel wire base material can choose low carbon steel hot rolled disk bar or hot rolled smooth steel bar. The base material number and diameter of cold-drawn low carbon steel wire can be confirmed according to the rules in the table below. During the cold drawing process, the surface shrinkage rate of each drawing should not be greater than the wire mesh before cold drawing. Annealing shall not be carried out during wire drawing. If butt welding is required, the same production unit and base material of the same number should be selected. The appearance quality of wire mesh should not affect wire drawing. When the welding function is poor or brittle fracture occurs, special inspection should be carried out according to relevant standards.

Although to be able to reduce the production cost, but the strength of the whole product will have a great lack of, so in this case will also let it have a great strength decline. Of course, in the shopping mall, the higher the intensity of the data in production, the higher the implementation of standards, naturally there will be certain progress in price.