fine thread drywall screws

6, passivation to remove hydrogen parts should be passivation after the removal of hydrogen, passivation before the application of 1%H2SO4 or 1% hydrochloric acid activation 5~15s. Passivation shall be treated with colored chromate unless otherwise specified in the design drawings.

5, when limited by the terrain, the barbed rope barbed rope protective net before and after the continuous setting, take the place as the end of the barbed rope protective net, and deal with the end of the sealing.

National standards on the use of wire mesh standards have certain requirements, diameter and mesh size matching use, rather than simply diameter, on the plaster layer to use the mesh should not be greater than 20×20, diameter is not easy to be less than 1mm, just choose diameter is not much meaning, choose 40×40×0.9 and choose 10×10×0.6 wire mesh, Which is better? I’m afraid it’s 10 by 10 by 0.6.

1, first of all, the net surface is smooth, mesh are four lines, pitch is the same, whether the weft wire bending (note: the net width is the length of the weft wire), normal weft wire passes through the straight wire of welded wire mesh, with accurate time and the silk repeated welding, make the pitch of welded wire mesh is consistent, with smooth surface, into a square hole, when the net vertical position from the top downwards see, weft wire is straight.

Non-proportional extension strength: It is mainly for hard steel without yield point. It is defined as the stress where the residual elongation of the standard distance part reaches 0.2% of the length of the original standard distance.