ss hole sheet

Latest articles

ss hole sheet

...

ss hole sheet ss hole sheet

Read More
  • steel

    ss hole sheet

    ...

    ss hole sheet ss hole sheet

    Read More
  • ss hole sheet

    ...

    ss hole sheet ss hole sheet

    Read More
  • galvanized

    ss hole sheet

    ...

    ss hole sheet ss hole sheet

    Read More
  • Wire factory introduction annealing wire is widely used mainly because it has good elasticity and flexibility, in the process of annealing can be very good control of its soft and hard degree, it is mainly made of iron wire, more often used in the construction industry tied wire use. In the production of annealing wire will be processed according to the performance of the material, according to the demand for different degree of hardness of its soft change, can make it has more advantages, can reduce the consumption of metal, reduce the cost of production.

    ss hole sheet

    ...

    ss hole sheet ss hole sheet

    Read More
  • The most obvious gap in a short period of time is the cross section of this piece, hot dip galvanized wire because it is surface anti-corrosion treatment, so in the cross section of this piece will appear rust, and stainless steel wire because the internal raw materials and surface raw materials are consistent, so there is no such situation.

    ss hole sheet

    ...

    ss hole sheet ss hole sheet

    Read More
  • Raw material of wire mesh sheet cold drawn low carbon steel wire base material can choose low carbon steel hot rolled disk bar or hot rolled smooth steel bar. The base material number and diameter of cold-drawn low carbon steel wire can be confirmed according to the rules in the table below. During the cold drawing process, the surface shrinkage rate of each drawing should not be greater than the wire mesh before cold drawing. Annealing shall not be carried out during wire drawing. If butt welding is required, the same production unit and base material of the same number should be selected. The appearance quality of wire mesh should not affect wire drawing. When the welding function is poor or brittle fracture occurs, special inspection should be carried out according to relevant standards.

    ss hole sheet

    ...

    ss hole sheet ss hole sheet

    Read More

  • Post time: 12-06-24

    ss hole sheet

    ...

    ss hole sheet ss hole sheet

    Read More
  • ss hole sheet

    ...

    ss hole sheet ss hole sheet

    Read More
  • 

    Popular articles

    Latest articles

    Links