3 x 3 wire mesh

Latest articles

The acceptance of cold-drawn low carbon steel wire shall be conducted according to the same production unit, the same raw material, the same diameter, and shall not exceed 30T for an inspection lot, and check the base material into the factory or out of the inspection statement. The inspection items for each inspection lot are appearance quality, diameter error, tensile test (including tensile strength and elongation) and repeated bending test.
3 x 3 wire mesh
...

3 x 3 wire mesh2025-08-14 19:42 【3 x 3 wire mesh】
Read More
3 x 3 wire mesh
...

3 x 3 wire mesh2025-08-14 19:07 【3 x 3 wire mesh】
Read More
3 x 3 wire mesh
...

3 x 3 wire mesh2025-08-14 18:28 【3 x 3 wire mesh】
Read More
3 x 3 wire mesh
...

3 x 3 wire mesh2025-08-14 18:25 【3 x 3 wire mesh】
Read More
3 x 3 wire mesh
...

3 x 3 wire mesh2025-08-14 18:20 【3 x 3 wire mesh】
Read More
Abandoned barbed wire guardrail network will generally choose classification pick up, classification gathering pick up and other methods, better to promote the better use of the whole highway guardrail network, abandoned metal guardrail network is still common copper mesh profile.
3 x 3 wire mesh
...

3 x 3 wire mesh2025-08-14 18:18 【3 x 3 wire mesh】
Read More
Post time: 05-09-22
3 x 3 wire mesh
...

3 x 3 wire mesh2025-08-14 18:08 【3 x 3 wire mesh】
Read More
No less than 5 disks should be extracted from each inspection lot for diameter error inspection. 1 point of steel wire should be extracted from each disk to measure steel wire diameter, and the actual diameter of steel wire at this point should be taken as the average value of the two vertical directions. The diameter error of cold-drawn low carbon steel wire should conform to the rules in the table below. The unqualified inspection batches shall be checked one by one, and the qualified batches can be used for engineering.
3 x 3 wire mesh
...

3 x 3 wire mesh2025-08-14 18:05 【3 x 3 wire mesh】
Read More
For single-layer wound non-rotating wire rope, it is necessary to strictly abide by the above principles, otherwise it is easy to cause permanent deformation of wire rope structure; In the case of multilayer winding, the rotation of the rope is determined by the orientation of the reel’s rope groove to lay the foundation for the next layer. The friction between the wire rope and the extrusion pressure of the multi-layer winding drum are large, and the disorderly rope phenomenon is easy to occur. Therefore, the wire rope with a diameter slightly smaller than the pitch of the rope groove and the diameter of the rope groove should be selected to add the touch area between the wire rope and the drum.
3 x 3 wire mesh
...

3 x 3 wire mesh2025-08-14 17:55 【3 x 3 wire mesh】
Read More
3 x 3 wire mesh
...

3 x 3 wire mesh2025-08-14 17:28 【3 x 3 wire mesh】
Read More

1
2
3
4
5
6
7
8
9
10

Popular articles

Small and medium-sized cat cages, dog cages and fences are mostly made of pure iron wire, wire diameter is generally between 2-5mm. Of course, the larger the cage, the thicker the wire, because the larger cage needs to withstand more force.

Remind you to buy galvanized iron wire, should be stored in dry, good ventilation conditions, do not contain corrosive gases, do not mix with the production of organic volatile gas paint, plastic and other substances in a good environment. If conditions, for galvanized parts to increase reliable inner packaging, and put desiccant. If the zinc layer white spots and hair, only mechanical removal, and then normal passivation, or thoroughly washed off the zinc layer after re-plating.

Different from the general zinc barbed rope, high zinc barbed rope surface zinc content is very high can reach the former 6-8 times, so in the service life also has a great advantage, ordinary products three or five years began to corrosion and the latter will take longer to change. Stainless steel barbed rope is in the material aspect of protection, so the durability is also better, these two products are long in the service life, but in the price is high.

Latest articles

Links