A. When the thickness of the plating is 3-4 mm, the zinc adhesion should be less than 460g/m, that is, the average thickness of the zinc layer is not less than 65 microns.

Most of the production enterprises or large public places, they can play a defense hook mesh in the choice of time, often will hook mesh quality in position, so galvanized hook mesh this product few people are interested in, but does this show that galvanized hook mesh is not useful?

Answer: hot water solution method: because HPMC is not dissolved in hot water, so the initial HPMC can be evenly dispersed in hot water, then quickly dissolved when cooling, two typical methods are described as follows:
1) Put the required amount of hot water in the container and heat it to about 70℃. Under the slow stirring gradually add hydroxypropyl methyl cellulose, HPMC began to float on the surface of the water, and then gradually form a slurry, the slurry cooling under the stirring.
2) Add 1/3 or 2/3 of the required amount of water into the container, and heat to 70℃, according to the method of 1), disperse HPMC, prepare hot water slurry; Then add the remaining amount of cold water to the hot slurry, stirring and cooling the mixture.
Powder mixing method: HPMC powder and a large number of other powdery material ingredients, mixing fully with a blender, then add water to dissolve, HPMC at this time can dissolve, and do not stick together, because each small corner, only a little bit of HPMC powder, water will dissolve immediately. - Putty powder and mortar production enterprises are using this method. [Hydroxypropyl methyl cellulose (HPMC) is used as thickening agent and water retaining agent in putty mortar.]

Commercial production