types of perforated sheet metal

A patent for an oil seal was filed by Nelson Thomas Edward on August 12, 1937, and published a year later. There were two purposes described. The device was to provide an oil seal between a fixed housing and a rotating part. The seal is described as

Oil seals are available in an immense range of sizes, for shafts from a few millimetres to several metres. Once the shaft diameter, groove diameter (housing diameter) and groove width are known, selecting an appropriate oil seal is a simple task. An oil seal or its product description is usually associated with three dimensions, for example 6x15x4. These refer to the sizes of the hardware for which the oil seal is designed. In this example, this oil seal is suitable for: 6-mm shaft diameter x 15-mm groove diameter x 4-mm minimum groove width.

3) Seal numbering system

No single physical property of rubbers is responsible for the successful performance of an oil seal or ‘O’ ring. The ultimate tensile strength, breaking elongation, modulus, shore hardness, creep and stress relaxation in tension and compression loads are all important physical properties that characterize a seal or ‘O’ ring. Compression strength and set together with stress relaxation or decay are important for effective sealing. The difference in these properties in a swollen seal is highly critical. An optimum swelling value in a fluid medium is a desirable feature. De-swelling decreases the seal pressure against the wall of the housing where the seal is fixed, leading to leakage. Over swelling minimizes the physical properties of the rubber. Seals made of polysulfide rubbers have extreme fuel resistance but undesirably high compression set. The effect of temperature on the seal is an important factor. Swelling under stress can increase at higher temperatures and a suitable compounding technique should be adopted to reduce this effect.