wiremesh custom

Full Synthetic Motor Oil

Wear and oil loss remains two of the most frequent signs of engine seal failure and, if not paid attention to, it can give rise to a breakdown in the vehicle’s system. Regular maintenance and routine oil changes minimize the issues associated with oil seals and potential oil loss. 

1) Seal type

As can be seen from the seal cross-section shown in Fig. 14.2, shaft seals are complex shapes that require advanced mold design and molding techniques (see Section 7.3 for discussion of fluoroelastomer molding). For some time, most shaft seals were made in the United States by compression molding. Injection molding of shaft seals is prevalent in Europe, and is being used increasingly in the United States. An advantage of compression molding is that preforms (usually rings cut from extruded tubing) are used that closely approximate the amount of stock required for the final parts, so compound waste is minimized. For injection molding, the amount of cured stock in the central sprue and runner (actually a thin sheet leading to the seal lip) is often large compared to the stock required for the final part, so the waste of high-cost fluoroelastomer may be high. Such waste is reduced in modern injection molding designs.

The durometer of an oil seal is typically dependent on the material it is made with. Common oil seal materials along with their durometers are as follows:

Oil Seal Materials

These problems can be overcome through a better understanding of the types of sealing materials available, redefined selection procedures and the consistent application of sound replacement and maintenance practices.