gi hexagonal wire mesh

Latest articles

gi hexagonal wire mesh

...

gi hexagonal wire mesh gi hexagonal wire mesh

Read More
  • The different spacing of the thorn rope is mainly in order to save costs to consider, because if they are too close, then obviously a little waste of resources, but the installation is too sparse will not work. Usually the bottom spacing is about 10cm, and the top is up to 20cm, this is because the higher the place is more difficult to climb over, usually more than one meter without the help of tools it is difficult for ordinary people to climb over, and the bottom because of the relatively tight can prevent personnel from drilling in the past.

    gi hexagonal wire mesh

    ...

    gi hexagonal wire mesh gi hexagonal wire mesh

    Read More
  • Before wall plastering, the wall column is connected to the gap construction wire mesh, which can play a certain strengthening and heat preservation effect. The mesh is hung on the interface surface of different grassroots, and the length of each side should meet the requirements of 100mm, so as to prevent shrinkage and cracking caused by different grassroots. Mesh wire diameter can also determine the effect and efficiency of construction, mesh fine laid up convenient soft, high construction efficiency; Of national standard can assure quality, but laid respect is inferior to fine construction fast.

    gi hexagonal wire mesh

    ...

    gi hexagonal wire mesh gi hexagonal wire mesh

    Read More
  • gi hexagonal wire mesh

    ...

    gi hexagonal wire mesh gi hexagonal wire mesh

    Read More

  • Post time: 16-05-22

    gi hexagonal wire mesh

    ...

    gi hexagonal wire mesh gi hexagonal wire mesh

    Read More

  • Post time: 24-10-22

    gi hexagonal wire mesh

    ...

    gi hexagonal wire mesh gi hexagonal wire mesh

    Read More
  • 3, with oil cloth (oil used cloth), carefully from inside to outside, including each cage wire repeatedly grinding many times. The front of the bird cage, the door flowers, where vision is often in place, are repeatedly rubbed in order to improve the surface finish, equivalent to “grinding”. Note: door flowers, arhat lines and other structures are delicate and fragile, do not break. This process, which requires time and patience, care, is also a process of observing and appreciating the cage. Use new cloth again, according to the above process, wipe again and again. This process is equivalent to polishing. For important parts, you can use a little force, the speed can be a little faster (do not use force). Be careful to fold the cloth neatly, otherwise marks will easily form. When this process is complete, the surface finish is significantly improved.

    gi hexagonal wire mesh

    ...

    gi hexagonal wire mesh gi hexagonal wire mesh

    Read More

  • Post time: 14-09-22

    gi hexagonal wire mesh

    ...

    gi hexagonal wire mesh gi hexagonal wire mesh

    Read More
  • gi hexagonal wire mesh

    ...

    gi hexagonal wire mesh gi hexagonal wire mesh

    Read More
  • The production process of large rolls of galvanized wire is a level of drawing, through the mold into a slightly smaller diameter than the original. And so on down to the desired length. One pull is not desirable, must be numbered, from coarse to fine is dependent on metal ductility. If it changes too much it just breaks. After drawing to a certain diameter, galvanized, so that the finished product.

    gi hexagonal wire mesh

    ...

    gi hexagonal wire mesh gi hexagonal wire mesh

    Read More
  • 

    Popular articles

    Latest articles

    Links