barbed wire fence cost per foot

Appellation: Hook fence is a variety of guardrail. The diameter of the opposite side of each mesh is generally 6.5cm-14cm. The thickness of the wire used is generally from 3.5mm to 6mm. Wire material is generally Q235 low carbon wire. The wire is welded by gimmick into decorative hook mesh black. The general size of the net is 1.5 meters X4 meters, 2 meters X4 meters, 2 meters X3 meters. The general surface treatment is cold (electric) galvanized treatment. There are also hot dip galvanizing, dip plastic, spray plastic. But overall, 99 percent is cold (electric) galvanized.

In addition, before the steel wire enters the zinc liquid, covered with a layer of insulation material containing zinc oxide reducing agent, can reduce the heat loss and zinc ash floating. In addition, adding zinc-5% aluminum-mixed rare earth alloy to the zinc solution, when the zinc solution contains 0.002%-0.005% aluminum mass fraction, can obviously increase the brightness of the zinc layer, and prevent the zinc solution surface oxidation caused by excessive zinc ash.

A pet carrier can be used as an indoor and outdoor pet house. The dog cage is equipped with a fixed food basin and drinking water, and the foot plate pet cage rubber pad has bayonets on four sides to be collated. According to the cage size can be splicing, cutting, disassembly is convenient, easy to clean, can solve the puppy in the ordinary cage foot clamping problem, prevent the puppy in the development of adverse reactions. The dividers are breathable and comfortable, and can be used as heat shields for pets in summer. A puppy with small feet that does not hold its feet or pinch its feet.

Packing and binding galvanized wire is in the liquid state of zinc, after a messy physical and chemical effect, not only on the steel plated thick pure zinc layer, and also generate a zinc-iron alloy layer. This kind of plating method, not only has the corrosion characteristics of the electric galvanized wire, and because of a zinc alloy layer. It also has strong corrosion resistance that can not be compared with electric galvanizing. Therefore, this plating method is particularly suitable for a variety of strong acid, alkali fog and other strong corrosive environment.

No less than 5 disks should be extracted from each inspection lot for diameter error inspection. 1 point of steel wire should be extracted from each disk to measure steel wire diameter, and the actual diameter of steel wire at this point should be taken as the average value of the two vertical directions. The diameter error of cold-drawn low carbon steel wire should conform to the rules in the table below. The unqualified inspection batches shall be checked one by one, and the qualified batches can be used for engineering.