1 in roofing nails

4, when the greenhouse special electric galvanized shaft wire from the well and winding to the roll, be sure to clean up the well fluid, mud sand and other things stuck on the wire, and also coated with protective oil.

For example, if the barbed rope is used to circle, the cost per meter is only a few yuan, if the ring with other products, it may be more than ten yuan or even 20 yuan, which undoubtedly increases the cost of the user again, so the cattle and sheep with barbed rope is the most economical product

To stop normalizing or soxhlet processing of wire rod, spheroidization annealing is used instead of large specification. In the middle, especially before the waste drawing process, the thermal disposal of soxhlet is widely used. Prevent decarbonization during thermal disposal. After hot disposal, sulfuric acid or hydrochloric acid pickling is used to remove the iron sheet. Coating can be used to dip lime, phosphating, borax treatment or copper plating.

For key and important parts with tensile strength greater than 1034Mpa, the stress should be removed at 200±10℃ for more than 1 hour before plating, and for carburized or surface hardened parts, the stress should be removed at 140±10℃ for more than 5 hours. The cleaning agent used for cleaning shall have no effect on the binding force of the coating and no corrosion on the substrate. Acid activation Acid activation solution should be able to remove corrosion products and oxide film (skin) on the surface of parts without excessive corrosion on the matrix.