black mesh screen for fence

With the rapid development of market economy, all walks of life are improving the production process and quality of products, galvanized iron wire industry is of course no exception. However, because of the different types of galvanized iron wire, its characteristics and production technology are also different. Galvanized wire selection of high quality low carbon steel rod processing, is the selection of high quality low carbon steel.

The bird cage is the main environment for the birds to live and live in. Only with proper cage and other accessories, can the birds be kept healthy and lively, singing freely and suitable for viewing.

Raw material of wire mesh sheet cold drawn low carbon steel wire base material can choose low carbon steel hot rolled disk bar or hot rolled smooth steel bar. The base material number and diameter of cold-drawn low carbon steel wire can be confirmed according to the rules in the table below. During the cold drawing process, the surface shrinkage rate of each drawing should not be greater than the wire mesh before cold drawing. Annealing shall not be carried out during wire drawing. If butt welding is required, the same production unit and base material of the same number should be selected. The appearance quality of wire mesh should not affect wire drawing. When the welding function is poor or brittle fracture occurs, special inspection should be carried out according to relevant standards.

The iron wire used for the barbed wire is woven or welded into low carbon steel wire, medium carbon steel wire, high carbon steel wire, stainless steel wire and other materials. Production process: general braided, embossed braided and spot welding. If the material is steel wire, after equipment processing into a network, it is called wire mesh.

Out-of-line annealing means that the recrystallization annealing of hot or cold rolled steel plate is carried out in the bottom type annealing furnace or cover type annealing furnace before entering the hot plating wire line, so that there is no annealing process in the galvanized line. The steel plate must maintain a clean active surface of pure iron, free of oxides and other dirt, before hot dip galvanizing. In this method, the annealed surface oxide sheet is first removed by pickling method, and then coated with a layer of zinc chloride or a mixture of ammonium chloride and zinc chloride solvent for protection, so as to prevent the plate from being oxidized again.