10d nail

Latest articles

• 4,  galvanized can be used zincate galvanized or chloride galvanized process, should use appropriate additives to meet the requirements of this standard coating.

  10d nail

  ...

  10d nail2025-08-16 09:55 【10d nail】

  Read More

• 

  10d nail

  ...

  10d nail2025-08-16 09:53 【10d nail】

  Read More

• Hot-dip galvanized wire has longer service life and better corrosion resistance than ordinary steel wire. Hot dip galvanizing is a method of chemical combination of zinc metal and steel wire surface, through the formation of a strong and self-healing zinc-iron alloy protective layer on the steel wire surface, so as to prevent direct contact between the steel wire and the external environment, reduce the possibility of oxidation corrosion, and extend the service life of the steel wire.
  

  10d nail

  ...

  10d nail2025-08-16 09:46 【10d nail】

  Read More

• In this temperature range, the zinc solution is severely corroded to the workpiece and the zinc pot, and the iron is lost at 560 degrees Celsius to add obviously, and the zinc will be the iron substrate above 660 degrees Celsius, zinc slag will be added quickly, plating cannot be used. Therefore, electroplating is carried out in the range of 430~450 degrees Celsius.

  10d nail

  ...

  10d nail2025-08-16 09:45 【10d nail】

  Read More

• 10d nail

  ...

  10d nail2025-08-16 09:26 【10d nail】

  Read More

• Knitting is also divided into two types, one is the ordinary knitting type, the other is the knitting type of embossing. Embossing is not simply used for knitting, but patterns can also be woven to add beauty. In short, it is a variety of steel wire as raw materials, through the professional screen material technology processing. It is widely used, mainly in construction.

  10d nail

  ...

  10d nail2025-08-16 08:52 【10d nail】

  Read More

• 

  10d nail

  ...

  10d nail2025-08-16 08:51 【10d nail】

  Read More

• 

  10d nail

  ...

  10d nail2025-08-16 08:27 【10d nail】

  Read More

• During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.
  

  10d nail

  ...

  10d nail2025-08-16 08:26 【10d nail】

  Read More

• 

  10d nail

  ...

  10d nail2025-08-16 07:41 【10d nail】

  Read More
• 1
• 2
• 3
• 4
• 5
• 6
• 7
• 8
• 9
• 10