concrete nails for furring strips
Latest articles
Alias: gabion mesh, heavy hexagonal mesh, ecological mesh, wire mesh, etc.
concrete nails for furring strips...
concrete nails for furring strips 【concrete nails for furring strips】
Read Moreconcrete nails for furring strips
...
concrete nails for furring strips 【concrete nails for furring strips】
Read Moreconcrete nails for furring strips
...
concrete nails for furring strips 【concrete nails for furring strips】
Read More2.0*2.0mm indicates that the two strands are 2.0mm silk, and the barbed wire wrapped around the strands is also 2.0mm silk.
concrete nails for furring strips...
concrete nails for furring strips 【concrete nails for furring strips】
Read Moreconcrete nails for furring strips
...
concrete nails for furring strips 【concrete nails for furring strips】
Read More
concrete nails for furring strips1, stress relief before plating where the maximum tensile strength is greater than 1034Mpa key and important parts before plating should be at 200±10℃ stress relief for more than 1 hours, carburizing or surface quenching parts should be at 140±10℃ stress relief for more than 5 hours.
...
concrete nails for furring strips 【concrete nails for furring strips】
Read MoreMost builders buy hot-dip galvanized wire. They want good corrosion resistance. And people use galvanized wire products in their daily life, such as wire mesh guardrail, galvanized wire is more, which still takes into account the cost. In addition, galvanized silk will also be used in the field of art. Artists are attracted to its bright color and softness, so the factory must consider these factors when producing galvanized silk.
concrete nails for furring strips...
concrete nails for furring strips 【concrete nails for furring strips】
Read More
concrete nails for furring stripsThe management system of the rinsing water after the steel wire pickling should be regularly and regularly discharged after the rinsing water, and the rinsing water should be kept clean and low acid value as far as possible. The pH control is more appropriate. The concentration of plating aid should not be too high. Hot plating wire must be added ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution is controlled in the range of 50~80g/L. The addition of ammonium chloride or zinc chloride raw materials without the results of laboratory analysis shall be subject to criticism and education, and economic treatment if necessary.
...
concrete nails for furring strips 【concrete nails for furring strips】
Read MoreThe strength of the hook mesh should be satisfied: when the vehicle is traveling at 80 kilometers per hour, the hook mesh will not fall into the river when it bumps against the rail at a 15 degree Angle. The shape and color of the hook mesh should be in harmony with the surrounding natural environment. The phenomenon planning of the important Bridges of the hook network should be done well. When the bridge crosses important traffic lines, such as expressways, urban rail transit, expressways, railway trunk lines, etc., the hook mesh should add the protective mesh on the pavement of the bridge deck.
concrete nails for furring strips...
concrete nails for furring strips 【concrete nails for furring strips】
Read Moreconcrete nails for furring strips
...
concrete nails for furring strips 【concrete nails for furring strips】
Read More
Popular articles
- Wire rod to stop normalizing or soxaustenitizing treatment, large specifications with spheroidizing annealing instead. In the middle, especially before the waste product drawing process of thermal disposal throughout the selection of soxaustenitizing disposal. Decarbonization should be prevented during thermal disposal. Sulfuric acid or hydrochloric acid pickling was used to remove the oxide sheet after hot treatment. Coating (see lubrication carrier) can be dipped in lime, phosphating, borax disposal or copper plating.
- Of course, the quality of any kind of product is also affected by the implementation of the specification of the manufacturer, if it is the welding screen manufacturers in the production of their own is not very high implementation of the specification, or in the production line of the procedure specification has declined, or there is no higher requirements on the production link.
Post time: 08-09-22Now most people buy barbed rope choose blade barbed rope, why is this? The blade gill net is made of hot-dip galvanized steel plate or stainless steel sheet to punch out sharp knife sheets. The high tension galvanized steel wire or blade barbed wire is made of stainless steel wire as the core wire. Because the gill net shape is not easy to contact, so it can reach excellent protection barrier effect. The primary raw materials of the product are galvanized sheet and stainless steel plate.
Galvanized iron wire is widely used in construction, handicrafts, wire mesh, highway guardrail, product packaging and daily civilian and other fields.
Latest articles
-
-
-
Steel wire after galvanized treatment, the surface will be covered with a layer of zinc metal, to play the role of anti-corrosion, anti-fouling, enhance strength and beauty. The galvanized wire drawing treatment is to process the steel wire by stretching method to obtain a finer, higher strength and smoother surface, and improve its mechanical properties. However, will wire drawing affect the electrical conductivity of galvanized steel wire?
-
-
Twisting hexagon mesh production factory is the selection of low carbon steel silk woven, mesh structure he has corrosion resistance, high strength and ductility and so on. The diameter of steel wire can reach 2.0mm-4.0mm. The surface of steel wire is usually used for hot-dip galvanized maintenance. The thickness of galvanized maintenance layer can be made according to the needs of customers.
-
Links
Post time: 05-07-22- 1. Zinc layer thickness: under normal circumstances, the thicker the zinc layer, the better the corrosion resistance of electrogalvanized wire. This is because the increase in the thickness of the zinc layer can improve the self-corrosion performance of the zinc layer and form a better protective layer.
- Five: Spray blade barbed rope specifications: BTO-10, BTO-12, BTO-18, BTO-22, BTO-28, BTO-30, CBT-60, CBT-65
Pay attention to safety in line collection and operation, others without the consent of the monitor, Ben have to get on the bus operation. The reels should be placed lightly, stacked firmly and neatly, not more than 5 reels. Direct contact with acid and alkali must be prohibited. When the acid fog exceeds the specified target of the state, measures should be taken to control it in time, otherwise production is not allowed.
There is no adhesion test of powder spraying or fluorocarbon spraying on packaged galvanized wire, but there are two points for reference: first, in sealed or air-free environment, non-metallic volatiles can corrode zinc coating; Second, zinc at higher than 230 degrees (c) will cause the matrix metal brittle. And powder spraying and fluorocarbon spraying are to be baked at a higher temperature and in a sealed environment, causing rapid corrosion of zinc, resulting in loose corrosion film resulting in coating adhesion decline, and even lead to (matrix) steel wire brittle situation may exist.
Post time: 27-04-22The construction of inner wall and outer wall steel wire mesh can effectively solve the wall cracks, falling off, empty drum phenomenon. Hot dip galvanized steel wire mesh material requirements: net surface leveling, width and length to meet the project required standards, welding process, weight, zinc, etc., with more production and operation, detection certificate is complete.
Cold galvanized by electrolytic action to metal and other materials surface attached to a layer of metal film, so that the surface of the material uniform texture, anti-corrosion wear, appearance is more beautiful. Hot dip galvanized coating is thicker, generally 30-60 microns, coating corrosion resistance is higher. Suitable for outdoor work of steel parts, such as highway fences, power towers, large size fasteners and other “rough” workpiece long-term rust prevention.
- 4, galvanized can be used zincate galvanized or chloride galvanized process, should use appropriate additives to meet the requirements of this standard coating.
- 2, oil: it is recommended to use cloth (there is a kind of textile cloth for polishing glasses, do not knit, because the nap is easy to fall off), oil to the inside and outside of the cage. The amount of oil is not much, because the bamboo material is old, density and hardness are relatively high.
- Now hexagonal mesh is used in a large number of Bridges, piers and bridge buttress inclined plane protection, bridge buttress inclined plane there are many kinds, people according to the inclination of the inclined plane to choose the right hexagonal mesh, and in the case of steep slope, people will use gabion mesh gravity protection wall. As we all know, the use of hexagonal net for protection can protect the natural environment while protecting the bridge, which can not only green the ecological environment, but also prevent soil erosion.
Post time: 20-02-23- The wide application of galvanized wire has brought great convenience to people’s production and life, but the production process of iron wire is not to be underestimated. In industrial production, the production process of galvanized wire should be strictly controlled to ensure the quality of galvanized wire.
- Selection of cage size tips
The cage door must be open so that the puppy can get out at any time. Once the puppy gets used to the dragon, it will go in without you urging it. Close the door for a few minutes when the puppy is having fun. But keep the crate in a busy area of your home, such as the kitchen. The puppy is relaxed and asleep in the safety of its cage. Cage trained puppies should not be caged for more than two hours during the day (unless you have to, but as soon as you get home from work let the puppy out). After getting used to the crate, the puppy is willing to stay in the playpen. Some dogs can’t stand the small space in a crate, but puppies are less likely to have this problem.
- When the temperature is running at the same temperature and the same heat is stored, the amount of iron dissolved is not the same. At around 500, the loss of iron increases sharply with the addition of temperature and insulation. It is lower or higher than 480~ 510c, and the loss of epitaxial iron is slower, and it is difficult to catch up with the duration. Therefore, everyone will call 480~ 510c the malignant melting zone.
- 5, when the terrain is limited, the barbed wire barbed wire protective net before and after can not be set continuously, this is the end of the barbed wire protective net, and handle the end of the sealing.
Post time: 23-02-23- Post-plating treatment of hot-dip galvanized wire for enhanced protection function, decoration and other special purposes (passivation, hot melting, closing and hydrogen removal, etc.). After galvanized, chromate passivation or other conversion treatment is generally required, forming the corresponding type of conversion film is one of the key processes to ensure the quality of plating. Because hot-dip galvanized wire has a long anti-corrosion life, a wide range of applications, hot-dip galvanized wire to net, rope, wire and other ways are widely used in heavy industry, light industry, agriculture, widely used in the manufacture of wire mesh, highway guardrail and construction engineering and other fields.
Post time: 25-10-221. The waterproof layer at the bottom of the cage should be checked regularly to prevent leakage at the bottom and replaced in time to avoid dropping liquid objects such as bird droppings, urine and water, resulting in corrosion of the cage edge.
- 2. The cleaning agent used for cleaning should have no effect on the binding force of the coating and no corrosion on the matrix.
Post time: 05-06-23- (3) For some use of special paint spraying should be baked, of course, depending on the size of the area, small can be placed in the oven, large can only be dried first, and then to dry parts for processing, lock baking, if other circumstances can only use high temperature tools bit by bit baking. The products that can be baked in the oven should be leveled at room temperature for 15 to 30 minutes, baked at a low temperature of 60 degrees Celsius for half an hour, and then baked at the reserved baking temperature for one and a half hours, and then cooled down.
Second: positive and negative twisting rope cost-effective
- 2. Breeding chickens, ducks, geese and other small animals, fruit and wood garden enclosure protection, medium breeding protection, it is recommended that you choose 2.3mm-2.5mm wire diameter products.
Post time: 11-01-23