316 stainless steel siding nails
Latest articles
316 stainless steel siding nailsThe production process of large rolls of galvanized wire is a level of drawing, through the mold into a slightly smaller diameter than the original. And so on down to the desired length. One pull is not desirable, must be numbered, from coarse to fine is dependent on metal ductility. If it changes too much it just breaks. After drawing to a certain diameter, galvanized, so that the finished product.
...
316 stainless steel siding nails 【316 stainless steel siding nails】
Read More
316 stainless steel siding nailsThe tensile strength of cold drawn spring steel wire is slightly higher than that of oil tempered steel wire. The large specification of cold drawn steel wire elastic force is too large, winding the spring is very difficult, so the cold drawn spring steel wire application specification is generally less than 8.0mm, oil quenching tempered steel wire application specification is generally less than 13.0mm. In fact, the diameter of 13.0mm spring is used to light tension spring steel wire, cold drawing wound made into shape and then quenched and tempered. Steel wire with diameter above 15.0mm is mostly made by heating winding process.
...
316 stainless steel siding nails 【316 stainless steel siding nails】
Read More
316 stainless steel siding nailsHere’s how to bathe a kitten.
...
316 stainless steel siding nails 【316 stainless steel siding nails】
Read More316 stainless steel siding nails
...
316 stainless steel siding nails 【316 stainless steel siding nails】
Read More316 stainless steel siding nails
...
316 stainless steel siding nails 【316 stainless steel siding nails】
Read More316 stainless steel siding nails
...
316 stainless steel siding nails 【316 stainless steel siding nails】
Read More316 stainless steel siding nails
...
316 stainless steel siding nails 【316 stainless steel siding nails】
Read More
316 stainless steel siding nailsGalvanized hexagonal mesh uses: building wall fixed, heat preservation, heat insulation; Power plant piping, boiler heating; Anti-freezing, residential protection, landscaping protection; Raise chicken and duck, isolate chicken and duck house, play the role of protecting poultry; Protect and support seawalls, hillsides, roads and Bridges and other waterworks.
...
316 stainless steel siding nails 【316 stainless steel siding nails】
Read More
316 stainless steel siding nailsNow the production of stainless steel blade barbed rope unless it is a specially customized model, under normal circumstances are the use of a knife length of 22mm mold production, that is, we usually say bto-22 type. It’s not necessarily the case that there are specifications from 11mm to 65mm. Unless the customer insists on customizing the required length, the barbed rope manufacturer produces bto-22 stainless steel blade barbed rope.
...
316 stainless steel siding nails 【316 stainless steel siding nails】
Read More316 stainless steel siding nails
...
316 stainless steel siding nails 【316 stainless steel siding nails】
Read More
Popular articles
Stainless steel blade barbed rope under normal circumstances, basically 20 or 30 years is no problem, but because of the problem of its own material will appear a certain degree of rust, this is also because usually stainless steel blade barbed rope used by the material is 304 material, in daily use if in a long-term humid environment will cause certain corrosion. But usually users buy stainless steel blade barbed rope is basically life will not have problems users can also rest assured to use.
Latest articles
-
When we buy barbed rope, we need to know the kilogram weight of each bundle and the length to be used, so as to decide which product to buy. Or let it check directly into how much money a meter, is also a means to avoid being cheated. What you need to know when buying is the weight, and the length of the barbed rope can be customized from 50-250 meters. If the barbed rope is installed in a large area, it is recommended to use the barbed rope of 250 meters to reduce the use cost and logistics and transportation costs.
-
-
-
-
-
3, reduce the bivalent iron ion in the plating aid used for hot plating wire, reduce the formation of zinc slag
Links
2, the production and installation is simple and fast, the use of patented friction connection or special connection accessories for installation, greatly improve the installation efficiency.
Fence use: The use of the fence is generally one meter two to two meters a height of the impregnated welding mesh, mesh mostly 6cm, wire diameter from 2mm to 3mm.
Pet cage You can choose a pet cage that you like or find suitable. It is recommended that you buy a metal cage, with a metal tray at the bottom, of course, the better is stainless steel, plastic can also be, but the plastic tray is very easy to be bitten by pets and damage, plastic tray is also easy to be pet uric acid corrosion, and plastic products are also low, not durable. So pet cages are usually made of metal. This will prevent the pet from entering the house and causing damage, while also providing it with maintenance and not getting sick from running around and touching dirty things.
1, galvanized wire mesh molding sheet must be packed with flat hard data, to avoid eternal deformation due to poor packaging. It IS VERY IMPORTANT THAT EACH PACKAGE AND ROLL OF RAW SHEET MATERIAL BE MARKED WITH PRODUCT NAME, STANDARD, QUANTITY, TRADEMARK, batch number, MANUFACTURER, DATE of production, STACKING SYMBOL, INSPECTOR CODE AND INSPECTION CERTIFICATE.
Hot dip galvanized coating is also relatively thick, but there is an uneven situation, for example, the thickness of the thin is only 45 microns, thick can reach 300 microns or even thicker, the color of this product is relatively dark. There is also a lot of zinc consumed in the production process. Zinc will form an infiltration layer with the metal. Its advantage is that it has good corrosion resistance. Electrogalvanizing, it is through the plating tank in the zinc one-way plating on the outside of the metal products, this way of making products is relatively slow, but its thickness is more uniform.
- The drawing process of the product drawing process has a great influence on the product function. Generally, a large total surface reduction rate of about 90% (see area reduction rate) and a small pass surface reduction rate (about less than 23%) are selected to ensure the endurance of the product. On the high strength spring steel wire, drawing should control the exit temperature of each passage of the steel wire is lower than 150℃, to avoid the steel wire due to strain aging and appear to change the crack, which is the formation of steel wire scrap the primary disadvantage.
Post time: 13-09-22
Post time: 28-11-22Hot dip galvanizing, also known as hot dip zinc, is the method of forming a layer of zinc coating on the surface of the workpiece after oil removal and rust removal, showing a clean and infiltrating surface, immediately immersed in the plating tank of zinc melting in advance. Cold galvanizing is the same after the removal of oil, in addition to lure, showing no pollution, infiltration of the workpiece hung into a special electroplating tank on the cathode, the anode with zinc. Switch on the DC power supply, zinc ions on the anode migrate to the cathode, and discharge on the cathode, so that the workpiece is coated with a layer of zinc layer hot dip galvanizing method.
2, hot plating wire plating after processing
Post time: 27-10-22- It helps to dissipate heat. Building grid (floor heating) has good thermal conductivity and heat dissipation, the appearance of heat dissipation effect is more average 2 cm, 2.5 cm, 5 cm, 10 cm, 15 cm, 20 cm. Wire rope thickness, net length, net width, mesh and other indicators can be stopped at any time according to customer request. The mesh surface, solder joint and mesh are all equal.
- Again: positive and negative twisting barbed rope appearance beautiful
After annealing, the extension rate of galvanized wire is increased, making the product more soft and increasing the scope of application of galvanized wire. After electric galvanized hot galvanized, electroplated copper and other widely used screen production. Building reinforcement binding with galvanized wire mesh braided with the first after plating, plating and other methods, after treatment of galvanized wire mesh or steel wire mesh, has good corrosion resistance, oxidation resistance characteristics, can be used in construction, petroleum, chemical, aquaculture, garden protection, food processing and other industries reinforcement, protection and heat preservation.
Post time: 28-06-22
Post time: 27-06-22
Post time: 05-05-22- One idea is to choose a cage three times the size of your dog. In terms of size, the top and corners of the cage are virtually unusable space for dogs. To put it simply, the choice of cage size, the length of the cage is twice the length of the dog, should be appropriate for the dog. However, the growth of the dog must be taken into account, so the cage must be purchased according to the size of the dog as an adult.
Some customers may not use the blade rope immediately when they buy it. Some are for retail and some are temporarily without the blade rope for site construction. At this time, customers need to follow up the characteristics of the blade rope for storage.
Post time: 12-12-22If the zinc coating is good, but when the light comes out in 3% nitric acid, there is a dark shadow on the coating, and the film is brown when passivation occurs, which may be caused by foreign metal impurities such as copper or lead in the galvanized liquid. When there is a problem in the process of galvanizing, check the temperature and current density first, and then measure and adjust the content of zinc and sodium hydroxide in the bath through the analysis of the bath. Whether DPE levels are low can be determined by Hull cell test.
Bird cage to keep clean, bird cage is the birds often live and activity place, so the bird cage should not only have a place to put water and food, but also need to be cleaned regularly to the bird cage, so as to reduce the parasite.
1. The diameter of raw materials and the thickness of the diameter have a direct impact;
As we all know, the mechanism of resistance to atmospheric corrosion of zinc includes mechanical protection and electrochemical protection. Under the condition of atmospheric corrosion, there are ZnO, Zn(OH)2 and basic zinc carbonate protective film on the surface of zinc layer, which to a certain extent slows the corrosion of zinc. When this protective film (also known as white rust) is damaged, a new film will be formed.
There are many types of steel wire mesh that can achieve the effect of fencing, but there are not many options to take into account the cost. For this kind of light poultry fence, it is recommended to use Dutch steel wire mesh. Most users call it green steel wire mesh.
Galvanized hexagonal mesh is a kind of galvanized metal wire mesh, the mesh shape is hexagonal.
- There is a good toughness and elasticity, in short, it can be easily made into a variety of shapes, and zinc as a coating is silver, very beautiful. This feature makes hot-dip galvanized wire handicrafts, wire mesh and other aspects are also used. Hot plating wire selection of high quality low carbon steel wire rod processing, is the selection of high quality low carbon steel, after drawing forming, pickling rust removal, high temperature annealing, cooling and other processes.