square steel with holes

square steel with holes

...

square steel with holes square steel with holes

Read More
  • Spring steel wire with high carbon quality carbon structural steel or carbon tool steel wire rod production, according to the use of spring strict control of its chemical composition, gas content and non-metallic inclusions. In order to reduce the appearance defect and decarbonization layer, the billet of consumption rod should stop the appearance grinding, and if necessary, stop the peeling.

    square steel with holes

    ...

    square steel with holes square steel with holes

    Read More

  • Post time: 16-03-23

    square steel with holes

    ...

    square steel with holes square steel with holes

    Read More
  • Ordinary installation of blade thorn rope on the wall and the height of the wall in two meters up and down the general construction costs in a dozen yuan a meter, but if it is said that the height of the prison construction ordinary wall has reached four or five meters so that the construction cost of each meter is about 30 or 40 yuan, mainly because of high altitude operation risk degree is relatively large reason. The construction cost is different, but the price of blade thorn rope is the same, often the construction cost is higher than the product, which is the thorn rope factory recommends customers to use better quality blade thorn rope, which eliminates the cumbersome time and cost of subsequent demolition and installation.

    square steel with holes

    ...

    square steel with holes square steel with holes

    Read More

  • Post time: 17-05-23

    square steel with holes

    ...

    square steel with holes square steel with holes

    Read More
  • 3. Keep the rinse water clean after pickling the steel wire

    square steel with holes

    ...

    square steel with holes square steel with holes

    Read More
  • square steel with holes

    ...

    square steel with holes square steel with holes

    Read More
  • When laying steel wire mesh, according to the laying method from the middle to both sides in turn. Wall plastering engineering use wire mesh material is generally two kinds: one is electroplating, the other is hot dip galvanized. The former has low cost and a wide range of use. The cost of hot-dip galvanized material is slightly higher than that of electroplating, and the cost is high and the life is good to prevent rust. Hot dip galvanizing is in the case of heating plating. After the zinc is melted into liquid form, the base metal is immersed in it so that the zinc interpenetrates with the base metal and binds so tightly that there are no other impurities or defects left in the process.

    square steel with holes

    ...

    square steel with holes square steel with holes

    Read More
  • No less than 5 disks should be extracted from each inspection lot for diameter error inspection. 1 point of steel wire should be extracted from each disk to measure steel wire diameter, and the actual diameter of steel wire at this point should be taken as the average value of the two vertical directions. The diameter error of cold-drawn low carbon steel wire should conform to the rules in the table below. The unqualified inspection batches shall be checked one by one, and the qualified batches can be used for engineering.

    square steel with holes

    ...

    square steel with holes square steel with holes

    Read More
  • 

    Popular articles

    Latest articles

    Links