perforated metal sheet architecture

Nitrile rubber (NBR)

 Oil seals go by many names, such as shaft seals, dirt seals, grease seals, lip seals, and many other variations of these. They are essentially simple devices used in rotary shaft equipment to prevent lubricant from escaping and for excluding contaminants such as dust, dirt and water. An oil seal’s most important function, however, is that it protects every type of ball, sleeve and roller bearing in the rotating shafts. The seals also prevent the integration of two different fluids that shouldn’t mix, such as oil and water.

Figure 4 shows the features of a JTEKT oil seal.

ERIKS type M (type B according to the DIN standard) has a single metal casing and rubber sealing lip. Since the casing is made of metal, it must be fitted in a well-finished, undamaged groove. Large volumes of oil seals with metal casings are often cheaper, which is why they are often used as original equipment in machines. However, if an oil seal has to be replaced, types with a rubber exterior (type R or RST) are easier to fit. Type MST is similar to M and commonly used. The difference is the dust lip in the MST oil seal that prevents dust and dirt reaching the sealing lip, and extends its service life in dusty environments.

Where loads are light, the outer skin layer can be made of silicone. It can be made of Fluroelastomer (orViton) to protect under high temperatures (more than 120 degrees Celcius). The skin can also be made of Poly Acrylate or Polytetra-FluroEthylene.