30m wire mesh

The production process of large rolls of galvanized wire is a level of drawing, through the mold into a slightly smaller diameter than the original. And so on down to the desired length. One pull is not desirable, must be numbered, from coarse to fine is dependent on metal ductility. If it changes too much it just breaks. After drawing to a certain diameter, galvanized, so that the finished product.

Take 20cm galvanized wire for acid fog experiment, check the zinc content of galvanized wire through the balance to see whether it meets the zinc layer standard required by the customer, ensure that the metal wire can achieve the role of rust and corrosion prevention, and meet the service life required by the customer. Galvanized iron wires must be packed in good condition, bound neatly and orderly, and bound with an inward end to prevent scratches during transportation. The inspection standard of galvanized iron wire also includes the tensile test. This item is determined according to the material of the galvanized wire order ordered by the customer, and it needs to be tested by comparing the raw material list.

The surface of the galvanized wire deposition layer before galvanized to remove the surface film layer, surface inclusion and other defects to the local, can be found and treated by conventional technology. Excess foam is caused by soaps and saponable fatty surfactants being brought into the tank. Moderate foam formation rates may be harmless.

The production process of stainless steel blade and galvanized blade is basically similar. The blade size is usually determined according to the mold.

Figure 2: Necessity of spring