welded wire bird cage panels
Latest articles
welded wire bird cage panels
...
welded wire bird cage panels 【welded wire bird cage panels】
Read Morewelded wire bird cage panels
...
welded wire bird cage panels 【welded wire bird cage panels】
Read More
welded wire bird cage panelsGalvanized hexagonal net is a kind of galvanized metal wire mesh, mesh shape is hexagonal.
...
welded wire bird cage panels 【welded wire bird cage panels】
Read More
welded wire bird cage panelsNow large roll galvanized wire in our life the use of more and more, to galvanized wire products bring a great market, galvanized wire products are more and more types. The surface coating of good quality galvanized wire is continuous and smooth. When the plating parts are installed and combined, there can be no flow hanging, slag or drop remaining, and no surface defects such as iron exposure. Good quality galvanized wire, coating must be uniform, roughly uniform in copper sulfate solution soaking five times without exposing iron. And with hammering test does not bulge, do not fall off. This is a good galvanized wire should have characteristics.
...
welded wire bird cage panels 【welded wire bird cage panels】
Read More
welded wire bird cage panels4, when the greenhouse special electric galvanized shaft wire from the well and winding to the roll, be sure to clean up the well fluid, mud sand and other things stuck on the wire, and also coated with protective oil.
...
welded wire bird cage panels 【welded wire bird cage panels】
Read More
welded wire bird cage panelsDuring this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.
...
welded wire bird cage panels 【welded wire bird cage panels】
Read MoreThe spring operating at high temperature requires that it can adhere to the elastic limit and good creep resistance at high temperature. In addition, the forming process and heat treatment process of spring steel wire should also be considered. Cold drawn spring steel wire and oil quenched tempered spring steel wire are directly around the supply of steel wire spring, spring forming after the elimination of stress directly used.
welded wire bird cage panels...
welded wire bird cage panels 【welded wire bird cage panels】
Read Morewelded wire bird cage panels
...
welded wire bird cage panels 【welded wire bird cage panels】
Read Morewelded wire bird cage panels
...
welded wire bird cage panels 【welded wire bird cage panels】
Read MoreD, coating adhesion; The zinc layer of the plating parts should be firmly combined with the base metal with sufficient adhesion strength, and will not fall off or bulge after the hammer test.
welded wire bird cage panels...
welded wire bird cage panels 【welded wire bird cage panels】
Read More
Popular articles
There are many kinds of galvanized solution, which can be divided into cyanide plating solution and cyanide plating solution. Cyanide galvanizing solution has good dispersion and covering ability, coating crystallization is smooth and fine, simple operation, wide application range, has been used in production for a long time. However, because the plating solution contains highly toxic cyanide, the gas escaping in the plating process is harmful to the health of workers, and the waste water must be treated strictly before discharge.
Because of its light weight, strength is relatively large has gradually begun to replace the original column. At the same time, due to the relatively uniform specifications, the barbed rope installation is also more beautiful. The direct spacing of the barbed rope is relatively fixed, which can effectively prevent crossing. At the same time, the mesh at the bottom is relatively dense, while the mesh at the top is relatively loose, which can save resources.
- General birds with a more dense small cage can be. Parrots, crossbilled birds and other large, special beak type hard food birds, to use a metal cage or bird rack.
Latest articles
-
-
Post time: 28-06-22 -
Post time: 08-09-22 -
-
-
Different from double strands of barbed wire to install directly on the ground, the blade thorn rope is fixed on some affiliate products just again, as was the case according to the common on the wall, often wall width is far lower than the diameter of the blade thorn rope under the premise of no such device is fixed in place, use special stents to prevent blade thorn rope can better protect us.
Links
Post time: 11-07-22
Cold drawing wire is a metal cold processing, with wire rod as raw material, that is, the mouth of the steel bar. Cold drawing wire is a product produced by a series of processes such as shell stripping, which is a common wire. In the development and production of metal materials, cold drawing wire is a very common material, its performance is good, the range of use is very wide, manufacturers in processing are the use of cold processing to produce.
In the process of composite plating, it is necessary to stir the plating solution to obtain the composite coating in which the particles dispersed in the matrix metal. Stirring methods include mechanical stirring, air stirring, ultrasonic stirring, bath circulation, etc. In the process of production, the acid activation solution can remove the corrosion products and oxide film on the surface of low carbon steel wire without excessive corrosion on the matrix. Galvanized wire can be used zincate galvanized or chloride galvanized and other processes, appropriate additives should be used to obtain the coating required by the standards of low carbon steel wire.
Breeding cattle and sheep with barbed rope effect or better, because the advantages of barbed rope more. Then the barbed rope used for animal husbandry effect is good?
Post time: 06-01-23
Post time: 22-02-23National standards on the use of wire mesh standards have certain requirements, diameter and mesh size matching use, rather than simply diameter, on the plaster layer to use the mesh should not be greater than 20×20, diameter is not easy to be less than 1mm, just choose diameter is not much meaning, choose 40×40×0.9 and choose 10×10×0.6 wire mesh, Which is better? I’m afraid it’s 10 by 10 by 0.6.
Post time: 08-02-23- Dip is one of the anticorrosion methods of galvanized diamond net. For hook mesh immersion is one of the methods of anti-corrosion, now the domestic more mature method is: powder immersion method, it originated from the fluidized bed method, the so-called fluidized bed is used in the Winkler gas furnace on the oil contact decomposition, and then developed the solid-gas two-phase contact process, gradually used in metal coating. So sometimes it is still called “fluidized bed coating method”, the actual process is to add the powder coating to the bottom of the porous, breathable container, the blower from the bottom into the treated compressed air, so that the powder coating turned to the “fluidization state”. It becomes a fine, evenly distributed powder.
- The most obvious difference in a short time is the cross section of this piece, hot dip galvanized barbed wire because of surface anticorrosion treatment, so there will be rust in the cross section of this piece, and stainless steel barbed wire because the internal raw materials and surface raw materials are consistent, so there is no such situation.
Barbed wire production of general selection of low carbon iron wire, after fine and accurate active welding equipment processing, the selection of galvanized process surface treatment. After the completion of the product, the net surface is smooth and regular, good integrity, strong consolidation, even if part of the trade-off or under pressure will not appear lax phenomenon.
- The wide application of galvanized wire has brought great convenience to people’s production and life, but the production process of iron wire is not to be underestimated. In industrial production, the production process of galvanized wire should be strictly controlled to ensure the quality of galvanized wire.
If not packaged, then a car of blade thorn rope can not be loaded with many pieces, but also relatively occupied places and easy to be lost in the process of transportation. Each bundle of blade barbed rope is 50 bundles. After hydraulic compression, the volume is reduced and it is more convenient to load and unload. Forklift trucks can load and unload easily. In general, when exporting, the blade thorn rope will be packaged for sale, so that the volume occupied in the container is relatively small, which can be very easy to size and place will not take up much place.
- Nemator roller cage is connected by nemator connecting clasp with longitudinal tension bar fixed on the support, and the connection between longitudinal tension bar and support is selected. The 2.5mm cold-drawn galvanized steel wire is wound 2 times and then tightened and fixed. The bracket is set on the column and the cross side of the protective fence with a span of 3m. Other spans are only set on the upper part of the column, and the bracket and the protective fence are connected with the bracket hoop.
3. Quality test report
Common galvanized iron wire equipment is usually used in barbecue net, barbecue net generally requires to have a long service life, with galvanized iron wire equipment to wire a layer of zinc, barbecue net is not easy to be corroded.
Hexagonal guardrail network custom corrosion lost the original characteristics, in the shape, color and mechanical properties will change, resulting in equipment damage, pipeline leakage, etc., specifically, it is easy to break, lose the original protection function.
Now most people buy barbed rope choose blade barbed rope, why is this? From the material blade barbed wire technology blade gill net is made of hot-dip galvanized steel plate or stainless steel sheet stamped out sharp knife sheet, high tension galvanized steel wire or blade barbed wire stainless steel wire as core wire combination of the resistance device. Because the gill net shape is not easy to contact, so it can achieve excellent protective barrier effect. The primary raw materials of products are galvanized sheet and stainless steel plate.
Galvanized hexagonal mesh features: easy to use; Save transportation costs. It can be reduced into small rolls, and involved in moisture-proof paper packaging, occupying little space. Coating thickness uniformity, corrosion resistance is stronger; Simple construction, no special technology; Strong resistance to natural damage and corrosion resistance and the ability to resist adverse climate impact; Can withstand a wide range of deformation and still not collapse. Play the role of fixed heat preservation and insulation.
Post time: 05-06-23The formation process of hot dip galvanized layer is between the iron matrix and the outside of the pure zinc layer, the formation of iron-zinc alloy process, the workpiece surface in hot dip plating when the formation of iron-zinc alloy layer, so that the iron and pure zinc layer is well combined. The process of large roll galvanized wire can be simply described as: when the iron workpiece is immersed in the molten zinc liquid, the first zinc and α-iron (body-centered) solid melt is formed on the interface. This is a crystal formed by the matrix metal iron dissolved with zinc atoms in the solid state. The two metal atoms are fused with each other, and the attraction between the atoms is relatively small.
Moderate rates of foam formation may be harmless. The presence of small, homogeneous particles of large denier in the tank can stabilize the foam layer, but the accumulation of excessive solid particles can cause an explosion.
Post time: 27-07-22
Post time: 09-08-22
Post time: 15-08-222) wire spacing: we all know that the smaller the wire spacing, the stronger the cage, in fact, too close is not good, too close to the dog will have a feeling of repression, we recommend that you buy wire spacing between 15-25mm, so it is not too close, and not too loose.
Some large roll galvanized wire products in order to meet different industrial needs, will be further processed on the surface, such as the anti-corrosion layer, galvanized, iron plating, aluminum alloy plating, or in the galvanized wire appearance above the copper plating, brass plating, etc., to strengthen the steel wire and colloidal years and capabilities. Generally, galvanized wire products should be well plated and drawn when they are produced, and the sequence of the two processes should be decided according to the production or industrial needs.
Post time: 14-03-23