3 drywall screws

During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.

In the process of using hot-dip galvanized wire, we should do a good job of daily overhaul and maintenance, try to avoid the destruction of the surface galvanized layer, and extend the service life of the wire. In addition to user binding, building special electric galvanized shaft silk production factory can also be used to decorate gardens and buildings, make it more beautiful and have higher taste.

Canary cage is also known as hibiscus cage, jade bird cage. Can be made of nickel-plated alloy or bamboo, for the refined round, square or rectangular (breeding cage) bird cage. The top of the cage has two kinds of flat top and dome, and the bottom of the cage is closed with a bottom circle. The circular cage is about 33 cm high and 20 cm in diameter; The square cage is 24.7 cm long, 24.7 cm wide and 33.8 cm high. The spacing of the cage is 1 cm, and the diameter is 0.2 cm. Cage bottom NEED NOT BAMBOO, MAKE IT WITH PLASTIC BOARD, bottom plate CAN move, FACILITATE PULL OUT WASH. Two perches are placed in the cage, and a food and drinking pot is placed in the cage. The cage has a board at the top of the cage to change the bird’s habit of looking up at the sky.