Application: Building materials

The policy of wire mesh mesh size, wire, square meter steel content, galvanized amount, etc., to consider the corrosion resistance of wire mesh ability and system safety! Wire mesh galvanized is more fierce than wire diameter, galvanized amount is very important, must be hot plating, welding after plating is better than the first plating after welding, as for wire diameter, summed up to consider the site construction and meet the needs of safety.

Raw material of wire mesh sheet cold drawn low carbon steel wire base material can choose low carbon steel hot rolled disk bar or hot rolled smooth steel bar. The base material number and diameter of cold-drawn low carbon steel wire can be confirmed according to the rules in the table below. During the cold drawing process, the surface shrinkage rate of each drawing should not be greater than the wire mesh before cold drawing. Annealing shall not be carried out during wire drawing. If butt welding is required, the same production unit and base material of the same number should be selected. The appearance quality of wire mesh should not affect wire drawing. When the welding function is poor or brittle fracture occurs, special inspection should be carried out according to relevant standards.

If the gap is larger than 0.002 in. (0.05 mm) at any point, have the head or block checked and machined flat by a specialist.

The perfect solution to this is to always use an oil seal that fits properly; the right size of the seal should be used. And in other cases, backup devices should be used to avoid the buildup of clearance gaps within the mating edges.

Click here to get in touch with us.