6x6 w2 9xw2 9 wire mesh
Latest articles
Application: The structure can be used for slope support, foundation pit support, mountain rock face hanging net shotcrete, slope planting (greening), railway highway isolation shield.
6x6 w2 9xw2 9 wire mesh...
6x6 w2 9xw2 9 wire mesh 【6x6 w2 9xw2 9 wire mesh】
Read More6x6 w2 9xw2 9 wire mesh
...
6x6 w2 9xw2 9 wire mesh 【6x6 w2 9xw2 9 wire mesh】
Read MoreAsk the factory to provide the corresponding quality inspection report before packing. Cold drawing is a kind of material often used in our life, especially in the construction of buildings. Cold wire drawing is used more in building materials, cold wire drawing testing standards are also different. The strength of cold wire drawing is high, and it can be used in many aspects. Where plasticity is not required, only strength is required, such steel can be used.
6x6 w2 9xw2 9 wire mesh...
6x6 w2 9xw2 9 wire mesh 【6x6 w2 9xw2 9 wire mesh】
Read More6x6 w2 9xw2 9 wire mesh
...
6x6 w2 9xw2 9 wire mesh 【6x6 w2 9xw2 9 wire mesh】
Read More
6x6 w2 9xw2 9 wire mesh
...
6x6 w2 9xw2 9 wire mesh 【6x6 w2 9xw2 9 wire mesh】
Read More
6x6 w2 9xw2 9 wire mesh
Post time: 18-04-23...
6x6 w2 9xw2 9 wire mesh 【6x6 w2 9xw2 9 wire mesh】
Read More6x6 w2 9xw2 9 wire mesh
...
6x6 w2 9xw2 9 wire mesh 【6x6 w2 9xw2 9 wire mesh】
Read More3. For temporary protection, breeding chickens and ducklings, etc., it is recommended that you choose products with a wire diameter of 2mm.
6x6 w2 9xw2 9 wire mesh...
6x6 w2 9xw2 9 wire mesh 【6x6 w2 9xw2 9 wire mesh】
Read MoreBarbed rope manufacturers specializing in galvanized barbed rope, hot dip galvanized barbed rope, blade barbed rope, stainless steel barbed rope, plastic coated barbed rope, positive and negative twisted barbed rope production for ten years.
6x6 w2 9xw2 9 wire mesh...
6x6 w2 9xw2 9 wire mesh 【6x6 w2 9xw2 9 wire mesh】
Read More6x6 w2 9xw2 9 wire mesh
...
6x6 w2 9xw2 9 wire mesh 【6x6 w2 9xw2 9 wire mesh】
Read More
Popular articles
The entire steel surface is protected, and the melted zinc is easily coated evenly, whether in the interior of the pipe fitting in a depression, or in any other corner where the coating is difficult to access. The hardness of galvanized coating is greater than that of steel. The Eta layer of the upper layer of Z is only 70 DPN hardness, so it is easy to be dented by collisions. However, the hardness values of the lower layer of Zeta layer and delta layer are 179 and 211 DPN respectively, which are higher than that of the iron material of 159 DPN. Therefore, its impact resistance and wear resistance are quite good.
Latest articles
-
4. Choose according to habits
-
Hot dip galvanized wire is dipped in zinc liquid melted by heating, with fast production speed and thick but uneven coating. The market allows a low thickness of 45 microns and a high of more than 300 microns. The color is dark, the consumption of zinc metal is much, and the matrix metal forms the infiltration layer, the corrosion resistance is good, the outdoor environment of hot dip galvanized wire can be maintained for decades.
-
-
Paint on the galvanized layer, the bonding force between each other has a great relationship with the baking temperature of the paint, and alkyd paint is coated after galvanized, and the adhesion is not a problem. After galvanized to do amino paint, paint adhesion is not very good. Do two bottom two surface, adhesion is good, if the two bottom two surface changed to two bottom three surface, that is, more paint, more baked once, again test adhesion is very bad, bad enough to tear the paint from the galvanized layer.
-
1. Electroplating process control
-
Links
5, the concentration of plating aid can not be too high, which is a factor that can not be ignored to reduce zinc consumption. The concentration of plating aid should not be too high. The galvanized line must be added with ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution should be controlled within the range of 50~80g/L. If ammonium chloride or zinc chloride is arbitrarily added without the results of laboratory analysis, it should be criticized and educated, and economic treatment should be given if necessary.
Stainless steel barbed wire in the way of corrosion is not too, because the surface is not treated but relies on its own raw materials for corrosion resistance, so there will be no chemical reaction.
- (5) We can surfacing the parts with wear and other failures, so as to obtain the surface surfacing layer with deep penetration, smooth surface and excellent performance.
Pet cage is generally made of high quality iron wire, low carbon steel wire, stainless steel wire welding, its characteristics are beautiful, light, folding, easy to store. Pet cage surface treatment is generally: cold galvanizing, hot galvanizing, spraying, dipping, chrome plating, nickel plating and other methods. Pet cage is mainly used for family breeding pets and protection.
- “Wet” hot dip galvanizing is also called “molten solvent method” hot dip galvanizing. Iron and steel workpiece through degreasing, pickling and cleaning, it is necessary to set in a special box above the surface of the molten zinc in the “molten solvent” (also called cosolvent), and then into the zinc liquid to galvanized. The molten solvent is usually a mixture of ammonium chloride and zinc chloride, but also other chlorine salts.
Post time: 17-05-22- (1) Protect and support seawalls, hillsides, roads and Bridges, river courses and other water conservancy projects;
Post time: 12-12-22- The strength of the hook net should be satisfactory: when the vehicle is traveling at 80 km/h, the hook net will not fall into the river when it bumps against the railings at a 15 degree Angle. The shape and color of the hook mesh should be in harmony with the surrounding natural environment. The phenomenon planning of important Bridges should be done well.
- 3. Galvanizing: the preheated steel wire is immersed in the molten zinc liquid, so that the surface is attached with a zinc layer. The control of galvanizing time and temperature has great influence on the quality of zinc layer.
When the coating of large galvanized wire is blistered in the process of galvanizing, the bath temperature should be checked first. If the bath temperature is not low, and then strengthen the removal of oil before plating, to prevent the base metal in acid corrosion. If you pay attention to these problems, the bubbling phenomenon still exists, it should pay attention to the dosage and quality of additives, then you can stop adding additives, with high current electrolysis for a period of time, to reduce the content of additives, observe whether the bubbling phenomenon is improved. If there is no improvement, check whether the additive has been stored for too long or whether it contains too many impurities.
- Knitting is also divided into two types, one is the ordinary knitting type, the other is the knitting type of embossing. Embossing is not simply used for knitting, but patterns can also be woven to add beauty. In short, it is a variety of steel wire as raw materials, through the professional screen material technology processing. It is widely used, mainly in construction.
- 5, the guardrail cavity is equipped with galvanized steel lining or aluminum alloy to strengthen, with enough strength and impact resistance, so that the guardrail has the strength and beauty of steel. Stainless steel welding mesh can be used in the construction industry, highway, bridge for reinforcement. Used for mechanical protection, industry, agriculture, construction and so on.
- Scope of use: Because the obtained coating is thicker, hot-dip galvanizing has very good protective function than electric galvanizing, so it is an important maintenance coating for iron and steel parts in strict working environment. Hot-dip galvanized products are widely used in chemical equipment, petroleum processing, Marine exploration, metal structure, electric power transportation, shipbuilding and other occupations. In agriculture, such as pesticide irrigation, greenhouse and construction industry, such as water and gas transportation, wire casing, scaffolding, Bridges, highway guardrail and other aspects, have been widely used in these years.
- Because the bundled galvanized wire is endowed with pre-tension, so it has the excellent characteristics of low relaxation value, small stress loss, good stability after loading, not easy to deformation, no fracture, strong elasticity, ordinary steel lines and rebar is difficult to match. The use of advanced galvanized finishing process, therefore, the use of hot-dip galvanized steel wire construction, not only good anti-corrosion performance, and beautiful generous. The product has the characteristics of smooth surface, high dimensional precision, good uniformity of zinc layer and firm adhesion.
- The effect of chemical composition and metallographic structure of steel wire
- (5) We can surfacing the parts with wear and other failures, so as to obtain the surface surfacing layer with deep penetration, smooth surface and excellent performance.
Large coils of galvanized wire are divided into hot dip galvanized and cold dip galvanized. Hot dip galvanized wire is dark in color, consumes more zinc metal, forms infiltration layer with the base metal, and has good corrosion resistance. Hot dip galvanized wire can be maintained for decades in outdoor environment. Cold galvanized production speed is slow, uniform coating, thin thickness, usually only 3-15 microns, bright appearance, poor corrosion resistance, generally a few months will rust.
- Generally speaking, it is necessary to install thorn rope in pasture, which is simpler and saves time and effort. It is better managed because it is full of spikes that keep livestock away from the barbed fence.
Post time: 24-02-23
Hexagonal mesh is made of galvanized iron wire woven by automatic mesh machine, mesh into regular hexagonal shape, mesh standard, beautiful, mesh size can be customized according to customer requirements, usually 27mm,20mm, 13mm, wire diameter from 0.40mm to 1.20mm, to meet the requirements of different customers.
Post time: 19-05-23Greenhouse steel pipe is mainly made of greenhouse composite materials made of pull rod, pressure rod, column, and arch rod to cover the plastic film in a greenhouse. Wire factory introduces its this shape is circular plastic greenhouse, this greenhouse covers a large area, the effect of heat absorption is also very good, convenient to build, the cost of building a is also very low. The raw material source of greenhouse steel pipe is very rich and extensive, and the application effect is good.
Now many industrial products will be made of stainless steel wire rope material. In order to identify the fake and inferior stainless steel, certain measures and methods can be taken. But many customers do not know what way to identify, listed the following identification methods for you.
In general, the cost of hot dipping zinc is lower than that of other maintenance coatings. The reason is very simple. Other maintenance coatings, such as sand painting, are labor-intensive processes, whereas hot dipping zinc processes are highly mechanized and tightly controlled in-plant construction. Hot dip zinc coating can be visually and briefly tested for non-destructive coating thickness.
- 1, prepare disinfection dog cage utensils: small brushes, old toothbrushes, latex gloves (can effectively prevent corrosive pure disinfectant damage to the skin), birdish, and household commonly used disinfectant.
Hot dip galvanizing of steel plate is also called hot dip galvanizing. Zinc ingots are melted in the tropics and some auxiliary materials are added in hot dip galvanizing. The steel grid parts are then soaked in a galvanizing tank and a galvanizing layer is attached to the steel plate. The strength of hot dip galvanizing depends on its corrosion resistance, and the adhesion and hardness of galvanized sheet are better. The amount of galvanized steel plate after galvanizing. So this is the general amount of zinc.
4, galvanized can be used zincate galvanized or chloride galvanized process, should use appropriate additives to meet the requirements of this standard coating.
3. Zinc layer structure: The structure of zinc layer includes grain size, grain shape and the combination of zinc layer and substrate, etc., which has a certain impact on corrosion resistance. In general, the finer the grain size, the denser the structure, and the better the corrosion resistance.
Post time: 06-03-23
Post time: 06-01-23