wire mesh 6x6 w2 9xw2 9

1. Zinc pot operators must stick to their posts

The production process of large rolls of galvanized wire is a level of drawing, through the mold into a slightly smaller diameter than the original. And so on down to the desired length. One pull is not desirable, must be numbered, from coarse to fine is dependent on metal ductility. If it changes too much it just breaks. After drawing to a certain diameter, galvanized, so that the finished product.

Plastic spraying is often referred to as electrostatic powder spraying. It is the use of electrostatic emitter to make plastic powder charged, adsorbed on the surface of the iron plate, and then baked at 180~220℃ to melt the powder and adhere to the metal surface. Plastic spraying products are mostly used in indoor boxes, and the paint film appears flat or matte. Spray powder mainly acrylic powder, polyester powder and so on.

Stainless steel wire drawing is a metal processing (stainless steel) process, is a popular surface treatment technology in stainless steel and aluminum products industry today. It is a wire drawing effect treatment for stainless steel and aluminum products. So galvanized wire and stainless steel wire are two different products. In order to remove the surface film and surface inclusions on the surface of the deposited layer, the defects can be found and treated by conventional techniques. Excess foam is caused by soap and surfactant saponable fats brought into the tank.