1 8 inch wire screen

1 8 inch wire screen

...

1 8 inch wire screen 1 8 inch wire screen

Read More
  • Zinc coating on steel and ferrous metal plays an anodic role, it is commonly used for those parts subjected to atmospheric or water action, but zinc coating only when the water temperature below 60℃, the anode properties. When the temperature is higher, the potential changes and the zinc to iron becomes the cathode. Therefore, for parts subjected to hot water (such as steam boilers), the zinc skeleton must be approximately 70 microns thick and void free. For parts subjected to low or normal temperature or atmospheric action, zinc coating without pinholes is not necessary.

    1 8 inch wire screen

    ...

    1 8 inch wire screen 1 8 inch wire screen

    Read More
  • Moderate rates of foam formation may be harmless. The presence of small, homogeneous particles of large denier in the tank can stabilize the foam layer, but the accumulation of excessive solid particles can cause an explosion. Using activated carbon mat to remove surface active substances, or through filtration to make the foam is not too stable, this is an effective measure; Other measures should also be taken to reduce the amount of surfactant introduced to Z.

    1 8 inch wire screen

    ...

    1 8 inch wire screen 1 8 inch wire screen

    Read More
  • 1 8 inch wire screen

    ...

    1 8 inch wire screen 1 8 inch wire screen

    Read More
  • 1 8 inch wire screen

    ...

    1 8 inch wire screen 1 8 inch wire screen

    Read More

  • Post time: 21-02-23

    1 8 inch wire screen

    ...

    1 8 inch wire screen 1 8 inch wire screen

    Read More
  • 1, stress relief before plating where the maximum tensile strength is greater than 1034Mpa key and important parts before plating should be at 200±10℃ stress relief for more than 1 hours, carburizing or surface quenching parts should be at 140±10℃ stress relief for more than 5 hours.

    1 8 inch wire screen

    ...

    1 8 inch wire screen 1 8 inch wire screen

    Read More
  • 

    Popular articles

    Latest articles

    Links