what are fine thread drywall screws used for

5, the concentration of plating aid can not be too high, which is a factor that can not be ignored to reduce zinc consumption. The concentration of plating aid should not be too high. The galvanized line must be added with ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution should be controlled within the range of 50~80g/L. If ammonium chloride or zinc chloride is arbitrarily added without the results of laboratory analysis, it should be criticized and educated, and economic treatment should be given if necessary.

Both sides of the galvanized welding net exposed can not be more than 2mm, so as to be qualified. And in the welding mesh of each warp and weft wire cross place, must be welded very firm, and if you want to welding very firm, both sides must have some warp and weft wire out, and the length must be controlled within two millimeters. From the mesh distribution is not uniform, galvanized is not uniform, but also to see whether the welding mesh is qualified standards.

The reason why there are black spots in wire mesh welding is that the action of wire feeding should be timely filled in the melting time, and the development should be appropriate. There is no argon gas, long burning, large current, long distance, blunt tungsten needle and high molten pool temperature are the fundamental reasons for blackening. Continuous burning, is about active welding machine energy selection, machine welding will appear black spots.