galvanized chain link

Barbed wire even in the mining industry also has a higher embodiment, because the selection of low-carbon materials to make it has a general iron mesh does not have the flexibility, determined its plasticity in the use, and then can be used in hardware crafts in the deep processing production, as the wall plastering, inside leak prevention crack and so on. Its light net body, the lower cost, can let the customer realize its economic benefits.

Cold drawing wire is a metal cold processing, with wire rod as raw material, that is, the mouth of the steel bar. Cold drawing wire is a product produced by a series of processes such as shell stripping, which is a common wire. In the development and production of metal materials, cold drawing wire is a very common material, its performance is good, the range of use is very wide, manufacturers in processing are the use of cold processing to produce.

The wire after the first plating, its strength limit is also higher than the first plating, plated zinc and then made of wire not only toughness and high strength. There is a lower figure in the strength limit of galvanized iron wire because of the quality of zinc, because the strength of zinc technology is several times smaller than the wire itself. It is difficult to hot-dip galvanize drawn wires, and it is impossible for finer and very fine wires to be coated with the desired thickness of smooth zinc.

There is no adhesion test of powder spraying or fluorocarbon spraying on packaged galvanized wire, but there are two points for reference: first, in sealed or air-free environment, non-metallic volatiles can corrode zinc coating; Second, zinc at higher than 230 degrees (c) will cause the matrix metal brittle. And powder spraying and fluorocarbon spraying are to be baked at a higher temperature and in a sealed environment, causing rapid corrosion of zinc, resulting in loose corrosion film resulting in coating adhesion decline, and even lead to (matrix) steel wire brittle situation may exist.